1.
ANALYSIS ON ASME FLANGE DESIGN RIGIDITY CALCULATION METHOD
美国ASME法兰设计刚度计算方法分析
2.
Analysis of Strength and Stiffness Behavior of Bus Body
公交车车体承载结构强度刚度计算分析
3.
Theory& method of stiffness calculation on the permanent magnetic bearing are presented.
提出了永磁磁力轴承刚度计算的理论和方法。
4.
Research on rigidity calculating for pole of the centrifugul concrete filled thin-wall steel tube
薄壁离心钢管混凝土电杆刚度计算的研究
5.
The Research of Lateral Stiffness of Wall in Brick Buildings with Bottom-framed;
底框—抗震墙结构墙体侧向刚度计算方法的研究
6.
The load, radial stiffness, axial stiffness and angular stiffness of precision spindle were formulated.
推导出精密主轴承载、向刚度、向刚度和角刚度的计算公式。
7.
Rotational Stiffness of Plated Column Base and Effective Length of Columns
平板柱脚的转动刚度和柱的计算长度
8.
On Calculation of Kinetic and Acceleration Energy of Rigid Body and Its System
关于刚体及刚体系的动能及加速度能计算
9.
Effective Length Factor of Columns in Two Web and Top-seat Angle Semi-rigid Connected Steel Frames;
四角钢半刚性连接刚架柱计算长度系数
10.
Computer aided calculation of angle stiffness of single axis flexible hinge
单轴柔性铰链转角刚度的计算机辅助计算
11.
Analysis and Study on Supporting Stiffness of High-speed Spindle System;
高速轴系支撑刚度的计算分析与研究
12.
Precamber Calculating and Controlling of Continuous Rigid Frame Bridge
连续刚构桥施工预拱度的计算与控制
13.
Analyse of strength and toughness to circular mold cavity in injection molding;
注射模具中圆形型腔强度与刚度的分析计算
14.
Finite Element Calculation for Strength and Stiffness of Gas Turbing Seat
燃气轮机压气基座强度和刚度的有限元计算
15.
The structural strength and flexural rigidity of the fuselage main frame are computed and verified by CAE system software and the results are analyzed.
应用CAE系统软件计算承力密封框的刚度和强度,并分析了计算结果。
16.
There are three calculated methods for lateral stiffness in current code.
根据现行规范,楼层侧向刚度的计算方法有3种。
17.
In this paper,using the finite element method,we completed the computation of static rigidity for a lathe bed.
本文介绍采用有限元法计算车床床身的静刚度。
18.
Stiffness Identification and Cable Force Calculation without Cable’s Section Information Available
斜拉索截面信息未知时的刚度识别及索力计算