1.
Effects of Vortex Generators on Maximum Lift and Stall Angle of Attack over Wings
旋涡发生器对机翼最大升力和失速迎角的影响
2.
and the rms of both wing tips and apex reaches maximum value for elastic wing around the stall angle α=20°.
而在失速迎角α=20°附近,机翼顶点和翼梢变形的方差最大。
3.
Research on Flight and Control of the TV Fighter s Post-Stall Maneuvers;
推力矢量飞机过失速机动仿真研究及大迎角非线性控制律设计
4.
The velocity distributions previously shown were for a single angle of attack.
先前的速度分布列分别为单一迎角.
5.
Pressure Distribution Characteristics around a Slender Circular Cone at 35° Angle of Attack and Low Speed
20°圆锥低速35°迎角下的压力分布特性
6.
Experimental investigation on pressure distribution characteristics of wings of ×× missile at supersonic speeds and high angles of attack
××导弹翼面超声速大迎角压力分布特性试验研究
7.
Research of Aerodynamic Characteristics for Double-bend Inlet in the Situation of High Incidence and Low Speed
低速大迎角下机腹双弯涵道空气动力性质研究
8.
Supersonic/Hypersonic Pitch Oscillating Derivatives of Two Dimensional Flat Plate at Arbitrary Angles of Attack
任意迎角二维平板的超声速和高超声速俯仰振动导数
9.
so does the ratio of lift anddrag, it gains only with the increase of the angle of release and goes to the maximum when the release angle is 25°.
升阻比和出手初速关系不大,它随迎角的加大而增大,迎角25°时达最大值。
10.
The cat whisked around the corner.
那只猫急速地拐过转角消失了。
11.
The thief whipped round the corner and disappeared in the crowd.
那个贼迅速转过拐角而消失在人群中。
12.
That man whipped round the corner and disappeared in the crowd.
那个男人迅速转过拐角，消失在人群中。
13.
Note that still the velocity is constant along the desired segments at the corresponding design angles of attack.
看到的依然是不断沿着速度预期在相应的环节设计迎角.
14.
On an Unsteady Aerodynamics Model for Pitching-Oscillating Body at High Angle of Attack
飞行器快速俯仰产生大迎角非定常气动力数学模型研究
15.
This attitude helps to generate greater lift and reduce the distance needed for takeoff or landing.
合适的大迎角，有利于在较低的速度下产生足够的升力，以便于减少起飞滑跑距离。
16.
The method of positive stall incidence calculation by Craig-Cox being revised and recent results of miscellanceous loss analyses being adopted, higher.
作者对正失速冲角计算方法作了修正,对叶型损失、二次流损失作了详细计算;
17.
curve of moment against incidence
力矩与迎角的关系曲线
18.
Angle tracking velocity and acceleration
跟踪角速度和角加速度