1.
The curve described by a point on the circumference of a circle as the circle rolls on the outside of the circumference of a second, fixed circle.
外摆线一个动圆沿另一个定圆外侧滚动时，动圆圆周上一点的轨迹曲线
2.
Generally Spiral Trajectory Curvature Center of Curvature and Torsion
一般螺线曲率中心轨迹的曲率与挠率
3.
The locus of the centers of curvature of a given curve.
渐屈线一给定曲线率中心的轨迹
4.
Trajectory Control of Spatial Intersected Curves in Automated Welding;
空间相贯曲线自动焊接中的轨迹控制
5.
Method Thoughts of Curve Simulation Based on VB.NET and MATLAB;
基于VB.NET和MATLAB的曲线轨迹模拟方法
6.
Algebraic Structure of Some Conic Curves and Pascal Lines Track;
一类二次曲线的代数结构及Pascal线的轨迹
7.
On Study of Trace Identification of Vane Pump Stator Curve;
关于叶片泵定子内曲线的轨迹辨识问题研究
8.
The Research and Realization of Alogorithm on Complex Track in Motion Control
复杂轮廓曲线的轨迹插补与速度控制方法研究
9.
Calculation of ray trace in bending fiber with numerical differentiation
数值微分法求解光纤弯曲时的光线轨迹
10.
Study on Motion Trajectory Smoothing Implementation for Curve Interpolation
曲线插补过程中运动轨迹平滑处理方法的研究
11.
Study of Reentry Trajectory Optimization of Maneuverable Warhead Based on Spline Curve
基于样条曲线的机动弹头再入轨迹优化研究
12.
The Automatic Generation Rescerch of Tool Paths for Surfaces Machinning Based on Space-Filling Curves;
基于填充曲线的曲面数控刀具轨迹自动生成算法研究
13.
Contouring NC systems can direct the tool or workpiece to move at any angle, and also along curved paths.
轮廓数控系统能将刀具或工件向任一角度,也可沿曲线轨迹移动。
14.
The curvature of the earth limits a microwave's line-of-sight path to about 30 miles.
地球表面的弯曲度把微波的直线轨迹限制到30英里左右。
15.
Bezier spline curve is adopted to form the motion track of the body center of mass and the foot of swing leg.
论文采用Bezier样条曲线构造人体重心及摆动腿脚部的运动轨迹。
16.
The vibration curve in θ φ plane is helpful to analyze the orbit of bob motion on the sphere.
θ φ面上的振动曲线有助于分析摆球在球面上的运动轨迹。
17.
The Optimal B-spline Based on Genetic Algorithm and Its Use in the Robot Trajectory Planning;
基于遗传算法B样条曲线优化在机器人轨迹规划中应用
18.
Research on Algorithm of Automatic Generation of Interference-free ToolPath of Freeform Surfaces with Curves of Cross Sections in the Machining of the Freeform Surfaces;
自由曲面加工中基于截面线法的刀具轨迹生成研究