1.
Research on Algorithm for One-Stationary Bistatic SAR
一端固定的双站SAR成像算法研究
2.
Stability and Critical Flow Velocity Analysis of a Clamped Pipe Conveying Fluid with Intermediate Support
一端固定具有中间支承输流管道临界流速及稳定性分析
3.
An anchored line thrown as a support to someone falling or drowning.
救生索一条一端固定的绳索，扔给坠落或溺水的人作为支撑物
4.
segmental motion
摆动[膜脂肪分子头部一端固定，另一端沿与膜法线垂直方向作钟摆运动]
5.
Vibration and stability are investigated for an axially moving beam constrained by a pinned end and a fixed end.
研究一端简支一端固支轴向运动梁的横向振动和稳定性。
6.
two wires of different metals are joined at both ends; one junction is at the temperature to be measured and the other is held at a fixed lower temperature; the current generated in the circuit is proportional to the temperature difference.
两段不同的金属线两端都接到一块；一端是被确定的温度，另一端是固定的低温。
7.
A thin rod for securing the ends of fractured bones.
不锈钢钉一种固定裂开骨头的末端的细钉
8.
The machine's moored at one end, points into the direction of the oncoming waves.
机器一端被固定，并指向波传播来的方向。
9.
A Solution Method of the Bending Moment of the Statically Indeterminate Beam with Constant Cross Section and Single-span;
等截面单跨超静定梁固端弯矩的一种解法
10.
Anatomic Plate Fixation Plus One Stage Bone Grafting for Treatment of Complex Bone Fractures of Terminal Femora
一期植骨解剖钢板固定治疗股骨下端复杂骨折
11.
The upperend rests against a flat washer.
上端紧靠固定垫上。
12.
Tighten the elastic a little. Pin the free end to the facing.
把松紧带收紧一点用大头针把没固定的一端钉在贴边上。
13.
To fix or secure(a nail or bolt, for example) by bending down or flattening the pointed end that protrudes.
敲弯，敲平通过弄弯或弄扁突出的一端来固定（如钉子或螺丝钉）
14.
When in place, the gasket will be seated and flush with the valve body ends.
放置好后，垫圈将与阀体连接端口一起固定和冲洗。
15.
The timber can be tailed in, ready to continue on the other angle.
柱子的一端可以固定在墙内，可呈不同角度继续延伸。
16.
Open Reduction and Internal Fixation for Distal Fractures of Humerus with AO LCP Metaphyseal Plates
双AO锁定钢板固定治疗肱骨远端骨折
17.
Limited internal fixation for distal radial unstable fracture
有限内固定治疗桡骨远端不稳定骨折
18.
ABNORMAL PHENOMENON WILL NOT OCCUR WITHIN4.5 KG NET WEIGHT FROM THE DTRECTION OF THE FIXING TERMINAL OF THE RESISTOR.
将电阻体的端子固定于一端,直接加重4.5公斤以内的重量,异常现象不会发生.