1.
Analysis of Orifice Compensated Mode Affecting Aerostatic Bearings Working Stiffness
小孔节流方式对气体静压轴承工作刚度影响的分析
2.
Analysis of Dynamic Characteristics of Aerostatic Bearing with Orifice Restrictors and Corresponding Rotor-Bearing System;
小孔节流静压气浮轴承—转子系统动力学特性研究
3.
The Design of Orifice Compensated Hydrostatic Bearing on Over Loading Crankshaft of Oxygen Compressor
氧气压缩机重载荷曲轴用小孔节流静压轴承的设计
4.
Optimization design and experimental model analysis of complex throttle injection with small apertures spray muffler
节流降压-小孔喷注消声器优化设计与模态分析
5.
orificing the coolant
对冷却剂加孔板节流
6.
a hand operated lever that controls the throttle valve.
控制节流闸流量的手孔杠杆。
7.
The holes themselves have a restricting or stabilizing effect because flow may become sonic.
因为这时流动可成为音速流动，所以这些小孔本身有一种节制作用或稳定化作用。
8.
Analysis of changes of pressure before the orifices in laterals under low pressure drip irrigation
低压滴灌小孔出流孔前压力变化研究
9.
Mount restrictor bar into the restrictor bar groove of upper die, mount adjusting bolt for restrictor bar into the bolt hole in the restrictor bar, then mount lower press block, upper press block.
在上模节流棒槽内装入节流棒，将节流棒调节螺栓装配进节流棒的螺丝孔中，再装配上压块。
10.
STUDY ON MEASUREMENT METHOD OF SMALL ORIFICE CONDUCTANCE USING GAS MICRO-FLOWMETER
气体微流量计测量小孔流导方法研究
11.
As for the selection of throttle orifice, methods for calculating the number of orifice stages, pressure difference and orifice diameter are described as well.
介绍了选择节流孔板的计算方法,包括节流孔板级数、力差和孔径的计算。
12.
Analysis of Flow Field Characteristic of Orifice and Study on Damping Grooves in Hydraulic Pump Valve Plate
节流孔流场特性分析及液压泵减振槽研究
13.
Investigation on magnetic oxide iron depositionof throttle orifice plate in once-through boiler water wall
直流锅炉水冷壁节流孔板磁性氧化铁沉积探讨
14.
Convective heat transfer simulation in holes of inclined multihole wall film cooling
多斜孔壁冷却方式小孔内对流换热的数值模拟
15.
The density P is that of the fluid escaping from the orifice.
上式中p是从小孔喷出的流体密度。
16.
Distribution Function of Velocities and Characteristic Velocities in the Course of Effusion;
小孔泻流速率分布函数及其特征速率
17.
ANALYTICAL METHOD CALCULATION AND MONTE CARLO CALCULATION OF THE ORIFICE CONDUCTANCE
小孔流导的理论计算与蒙特卡罗计算
18.
An experimental study of drilling small and deep blind holes with an abrasive water jet
磨料水射流钻削深小盲孔的试验研究