1.
Effects of Dimensional Tolerance on Sealing Characteristic of O-ring;
O形橡胶密封圈尺寸公差对密封性能的影响
2.
Finite Element Analysis of Stress and Contact Pressure of Rubber O-sealing Ring with Back-up Ring
O形橡胶密封圈配合挡圈密封的应力与接触压力有限元分析
3.
" Fluid systems--Sealing devices--O-rings--Inside diameters, cross-sections, tolerances and size identification code"
GB3452.1-1992液压气动用O形橡胶密封圈尺寸系列及公差
4.
Fluid power systems--O-ring--Design criteria for O-ring housing--Basic calculation
GB/T3452.3-1988液压气动用O形橡胶密封圈沟漕尺寸和设计计算
5.
Test methods for rubber O rings
GB/T5720-1993O形橡胶密封圈试验方法
6.
Appearance quality acceptance criteria for rubber O-rings
GB/T3452.2-1987O形橡胶密封圈外观质量检验标准
7.
Study and Design of High Pressure Vessel Based on Rubber O-ring Sealing;
基于O形橡胶圈密封的高压容器设计和研究
8.
Finite Element Analysis on Rubber Sealing Y-ring in the Condition of Static Seal
静密封条件下Y形橡胶密封圈有限元分析
9.
rubber sealing ring for medical sterite cooker
医用消毒锅橡胶密封圈
10.
rubber sealing ring for pressure cooker
日用压力锅橡胶密封圈
11.
The Non-linear Contact Finite Element Analysis of the Mouth Shaped Rubber Sealing Ring
唇形橡胶密封圈非线性接触有限元分析
12.
The Application of Finite Element Method in the Design of Rubber Sealing Y_X-ring
有限元分析法在Y_X形橡胶密封圈设计中的应用
13.
Gaskets and O rings are made of elastomers.
密封垫和O型环是由人造橡胶制成的。
14.
"On the standard seals, the secondary sealing bellows (flexible elastomer bellows) and the o-ring are Viton material for maximum performance."
在标准的密封上,次密封波纹管(柔软的弹性波纹管)和O形环采用性能最好的氟橡胶材料。
15.
Appearance quality for reciprocating rubber seals
GB/T15325-1994往复运动橡胶密封圈外观质量
16.
Medium or High-pressure Seal Design of SrO·6Fe_2O_3 MNBR
SrO·6Fe_2O_3磁性丁腈橡胶中高压密封圈设计
17.
Finite Element Analysis of O-Ring with Single Side Gasket
加有单侧挡圈的O形密封圈有限元分析
18.
Reciprocating rubber seals-Design criteria for standard applications-Part 3: rubber seals for wipers
GB/T10708.3-1989往复运动橡胶密封圈结构尺寸系列第三部分:橡胶防尘密封圈