说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 低频减负荷
1.
Study and Application of Optimal Setting of Underfrequency Load Shedding in Power System;
电力系统低频减负荷优化配置的研究及应用
2.
under frequency load shedding
低频率自动负载减少
3.
Negative Control Effects of UFLS and UVLS
低频低压切负荷的控制负效应及其机理
4.
Method to Reduce Flameout of Steady Burnable Boiler during Low Load Period
锅炉低负荷稳定燃烧减少熄火的对策
5.
Optimization and Coordination of UF/UVLS Placement and Multi-step Load Shedding
低频低压切负荷布点及轮次的优化与协调
6.
A Review on Optimization and Coordination of Under Frequency/Voltage Load Shedding
关于低频低压切负荷决策优化协调的评述
7.
Research on Load Characteristics Effect on Low-frequency Oscillation in Power System;
负荷特性对电力系统低频振荡影响的研究
8.
Influence of load characteristics on low frequency oscillation in cross-regional power grid
负荷特性对跨区大电网低频振荡的影响研究
9.
Professor Benton said a low GL breakfast helped curb obesity by discouraging snacking.
本顿教授认为低血糖负荷的早餐抑制零食摄入,有助减肥。
10.
Effect of decreased cardiac preload on central blood pressure and aortic augmentation index
心脏前负荷减低对主动脉压及主动脉扩增指数的影响
11.
Design and Analysis of Under Frequency Load-shedding Schemes Concerning Governor
计及调速器特性的低频切负荷方案的设计及分析
12.
When the load is lower than the standard, the cost will be given to users as an allowance.
路段交通负荷低于路段负荷标准时补贴给用户。
13.
This paper introduces with examples the measures adopted by several European pulp and paper enterprises in decreasing the rinsedosage and reducing discharge pollution load.
本文以实例的形式介绍了几家欧洲制浆]纸企业减少清水用量、低排水污染负荷所采取的措施。
14.
If we compensate the pump station with lower power numbers for electric power and electric capacity, we can reduce the current load in the power source and the lines.
对已建成的功率因数偏低的泵站采用电力电容补偿,可减少电源和线路的电流负荷。
15.
Undershoot Undershoot refers to the amount by which voltage or frequency drops below the nominal value as the voltage regulator or governor responds to changes in load.
下超调下超调指电压调整器或控制器在应对负荷变化时,电压或频率低于额定的量。
16.
Multicast can also reduce the load placed on network servers.
多播也能减少网络服务器上的负荷。
17.
If the error occurs when accelerating/decelerating: Please examine the inertia.
加速、减速时发生错误:请检查惯性负荷。
18.
The ratio of the average power loss to the power loss under peak loading.
平均能量衰减与峰值负荷时能量衰减的比值。