1.
A load-break switch will switch normal load currents but will not interrupt short circuit cur- rents.
负荷开关可开断正常负荷电流但不能开断短路电流。
2.
The weakened superficial layers of cartilage develop fi ures in re o e to increased deformation by normal loads.
变弱的表层软骨因对正常负荷增加变形而发生裂隙。
3.
Electrical positives attract electrical negatives.
正电荷吸引负电荷。
4.
Load Outlier Identification and Correction for Deterministic Contract Decomposition
确定性合同分解中异常负荷数据的识别与修正
5.
Make sure your tires are inflated to the correct levels and do not exceed the load limit of your vehicle.
确保你轮胎的充气量在正常的范围内并且不超过开车的负荷。
6.
Effect of chronic salt loading on vascular endothelium markers in normotensive salt-sensitive people
慢性盐负荷对血压正常盐敏感者血管内皮标志物的影响
7.
Changes of ventilation threshold and lactic acid threshold during load gradually increased exercising in normal and hypoxic environments
正常和低氧环境下递增负荷运动时通气阈、乳酸阈的变化
8.
"Load contacts 3-4, 5-6 and 7-8 will change from their normally open or normally closed position when the control energizes."
当控制装置激活时,负荷端子3-4,5-6和7-8将改变正常开启或正常关闭状态。
9.
An electron with a negative charge, as contrasted with a positron.
电子带有负电荷，与正电荷相反的电子
10.
Neutron has no charge, either positive or negative.
中子既不带正电荷，也不带负电荷。
11.
Two negative charges repel each other, and so do two positive charges.
两个负电荷相斥，每个正电荷也是如此。
12.
Electrons are negatively charged with electricity; protons are positively charged
电子带有负电荷，质子带有正电荷。
13.
Electrons are negatively charged with electricity,protons are positively charged.
电子是带负电荷的,质子是带正电荷的。
14.
Two negative charges repel each other , and so do two positive charges .
两个负电荷相斥，两个正电荷也是如此。
15.
Proper arrangement of the load and intensity for sprint training
正确安排短跑训练的负荷量和负荷强度
16.
Similarly, either an addition of positive charge or a removal of negative charge will result in an excess positive charge.
加入正电荷或移出负电荷，都将同样地导致过剩的正电荷。
17.
If a body is nonelectrified, the positive charges balance with negative ones.
如果一个物体不带电，它的正电荷与负电荷相等。
18.
During changing load (or power factor) the excitation system must respond to maintain the proper voltage at the generator terminals.
负荷(或功率因数)改变时,励磁系统必须迅速作出响应以维持发电机的正常端电压。