1.
Experiment and Study on the Pivoted Pin Strength and the Stress Near the Pivot-Point of Articulation System of Wheel Loader
装载机车架铰接系统铰销强度及铰点附近应力分布的试验研究
2.
Discussion About the Problem of Shearing Point Forward Shiftting During Demolition by Controlled Blasting
控制爆破拆除中转铰点前移问题探讨
3.
Hinge loading calculation on excavating forces for Doosan DH80-7 excavators
斗山DH80-7挖掘机整机挖掘力下的铰点力计算
4.
Calculation of the Force Acted on Hinged Joints of the Hydraulic Excavator Based on ADAMS
基于ADAMS仿真技术的挖掘机铰点受力分析
5.
Design calculating method and application for excavating mechanism with three hinge points linkage
三铰点连杆挖掘机构的设计计算方法与应用
6.
Oil that squeaky hinge.
给那个吱吱作响的铰链上点油。
7.
a pin or bolt forming the pivot of a hinge.
一个钉或门闩以形成铰链的支点。
8.
Optimization of Hinge Point for Direct-lift Construction;
直顶式举升机构铰支点位置优化设计
9.
Design Method of the Headed Stud Embedded at the Pinned Joint of Steel Beam to Concrete Wall
钢梁-混凝土墙铰接节点栓钉预埋件的设计计算
10.
The Stability Performance of RC. Curved Girder Bridge Supported by Single-Column;
独柱单点铰支承砼曲线梁桥的稳定性能研究
11.
Experimental Study on Energy Dissipation Hinge of Different Yield Reinforcement Concrete Structure;
不同屈服点钢筋混凝土结构耗能铰的试验研究
12.
The Number of Insert Point in the Design of Function Replace of Plane Linkage;
铰链连杆机构函数再现设计中插值点的数目
13.
Single-point Flat Hinge Horizontal Rotary Construction Technique for Large-span Cable Stayed Bridge
大跨度斜拉桥单点平铰水平转体施工技术
14.
On the Single-point Turning Construction Technology of the Single Pylon and the Single Plane Cable-stayed Bridge
独塔单索面斜拉桥单点平铰转体施工技术
15.
On the Problem About the Solution Areas and Infeasible Solution Areas of the Crank Fixed Hinge Center-point
对曲柄铰链中心点之解域和非解域问题的讨论
16.
ANALYSIS OF THE INFLUENCE OF THE GUSSET PLATE TO THE BRACED FRAME STRUCTURE WITH PINNED CONNECTIONS
支撑节点板对铰接支撑框架体系的影响
17.
Kinematic analysis of the revolute four-bar change-point mechanism at change-points
铰链四杆变点机构在变点位置的运动分析及其构形
18.
Point-to-point systems are suitable for hole-machining operations such as drilling, countersinking, counterboring, reaming,Boring, and tapping.
点位系统适用于钻孔、锪孔、扩孔、铰孔、镗孔、攻丝等孔加工。