1.
Reformation of teaching method on absolute maximum bending moment of simply supported beam
简支梁绝对最大弯矩计算方法的教学改革
2.
Bending moments produced by lift generally have only a small effect on the resultant bending moment.
一般由升力所产生的弯矩对最终的弯矩只有很小的影响。
3.
On the influence of the bending moment waveform disturbance on the pure bending beam flexion
弯矩波形扰动对纯弯梁弯扭屈曲的影响
4.
The calculation of ledger maximum bending moment and deformation the even load of scaffold board and live loads above the ledger.
按照大横杆上面的脚手板和活荷载作为均布荷载计算大横杆的最大弯矩和变形。
5.
The Influence of Cold-Formed Effect to Stress Capacity Performance of Cold-Formed Rectangular Hollow Section Beams;
冷弯效应对冷弯矩形钢管梁受力性能的影响
6.
COMPARATIVE STUDY ON BENDING STRENGTHENING METHOD OF NEGATIVE MOMENT AREA AT BEAM END IN RC FRAME
梁端负弯矩区受弯性能加固方法对比试验研究
7.
The Analysis of Moment Magnifier for Reinforced Concrete Arch Bridge;
钢筋混凝土拱桥弯矩增大系数的分析
8.
The maximum absolute value of a periodically varying quantity.
振幅周期性变量的最大绝对值
9.
An Interval Combination Forecasting Model of Minimizing Maximum Absolute Error
最大误差绝对值达到最小的区间组合预测模型
10.
An Efficient Algorithm for Solving Inverse Max-min Eigenvalue Problem of Symmetric Arrow-head Matrices
对称箭形矩阵最大最小特征对的逆特征值问题的一个有效算法
11.
The trouble with the profit system has always been that it has highly unprofitable to most people.
利润制度的最大弊病始终是绝大多数的人是绝对无利可图的.
12.
The trouble with the profit system has always been that is was highly unprofitable to most people.
利润制度的最大弊端始终是绝大多数的人是绝对无利可图的。
13.
drive axle maximum input torque
驱动桥最大输入扭矩
14.
steering gear max. Output torque
转向器最大输出扭矩
15.
When shearing force or axis force is relatively great, great errors of moment arise when the method of pure bending is employed.
当剪力或轴力较大时,用纯弯曲方法计算弯矩误差很大。
16.
The limit bending capacity of a round-corner-rolled crankshaft is measured with the testing machine.
利用该试验机对日本大发公司生产的经过圆角滚压处理的曲轴的极限承载弯矩进行了测试。
17.
Moment Amplification Factors of Columns in Frame-Flexural Bracing Systems and the Overall Elastic Stability;
框架—弯曲型支撑体系中框架柱的弯矩放大系数及整体弹性稳定
18.
Study on Influence of Beam-to-slab Relative Stiffness on Moment of Cast-in-situ Slab;
梁板相对刚度对现浇板弯矩的影响研究