1.
indirect-pressure interlayer-inflated transfusion bag
夹层充气加压式输血袋
2.
The Empirical Study of the Effect of Intermittent Pneumatic Compression on Fracture Healing;
间歇性充气加压疗法对骨折愈合影响的实验研究
3.
Research on Intermittent Pneumatic Compression Systems to Prevent Lower Extremity Deep Venous Thrombosis after Hysterectomy
周期性充气加压预防子宫切除术后下肢深静脉血栓的研究
4.
Comparison of intermittent pneumatic compression system with low-molecular-weight heparin for the prevention of deep-vein thrombosis after total hip replacement
周期性充气加压预防髋关节置换术后下肢深静脉血栓的效果
5.
Comparison of the Use of Intermittent Pneumatic Compression System with the Use of Low-molecular-weight Heparin for the Prevention of Deep-vein Thrombosis after Total Hip Replacement;
周期性充气加压对髋关节置换手术后下肢深静脉血栓预防的临床研究
6.
The Effects of Intermittent Pneumatic Compression on Theology Evalution in Aged Patients with Intertrochanteric Fracture after Operation
间歇性充气加压泵对老年股骨转子间骨折术后患者血液流变学的影响
7.
accumulator air-charging manifold
蓄压器充气阀箱压缩空气瓶充气阀箱
8.
tyre inflation pressure warning tell-tale
轮胎充气压力警报灯
9.
Factor analysis of pressure used in managed pressure drilling on injected gas
充气控压钻井过程压力影响因素分析
10.
With a supply of compressed air the large balloon inflated in a matter of seconds
大气球注入压缩空气後,几秒钟就充足了气
11.
With a supply of compressed air the large balloon inflated in a matter of second.
大气球注入压缩空气後，几秒钟就充足了气。
12.
Always replace the cap (where used) after checking air pressure or inflating a tire
检查气压或充气后,应该把轮胎气门盖放回原处。
13.
Sufficient deep breathing. Reduce the atmospheric pressure inside body, make abdominal muscle sufficient enlist campaign.
充分深呼吸。降低体内气压，让腹肌充分参与运动。
14.
Prevention of Lower Extremity Deep Venous Thrombosis Under Different Usage Time of Automatic Sequential Pneumatic Compression Pumps During Perioperative Period in Hip and Knee Joint Surgery
髋膝关节围术期序贯加压充气泵不同使用时间预防下肢深静脉血栓研究
15.
The glut of oil depressed gas prices.
石油充斥压低了天然气的价格。
16.
pressurized motor
充高压气体的密封电动机
17.
Generic specification for gas-filled voltage Stabilizing tubes
GB/T14186-1993充气稳压管总规范(可供认证用)
18.
Gas Gap Pressure During Mold Filling Process in Expendable Pattern Casting
消失模铸造充型过程气隙压力的研究