1.
The range of gears cut by the hob of small pressure angle
小压力角滚刀加工齿轮的齿数范围
2.
The value is out of range. The valid range is from %1 to %2.\0
数值超出范围。有效范围是从%1到%2。\0
3.
d range of spindle speeds
主轴转速级数和范围
4.
the greatest amount of something that is possible or allowed.
范围的极限最大的数量。
5.
the limits of the values a function can take.
一个函数的取值的范围。
6.
a great amount or extent.
数量大范围广程度深。
7.
"The value is out of range. The valid range is from %1 to %2 in increments of %3.\0
"数值超出范围。有效范围是从%1到%2，以%3递增。\0
8.
The transmission gear or corresponding gear ratio used to produce the range of lowest drive speeds in a motor vehicle.
头档，低速齿轮限定机动车辆最低驾驶速度范围的传动齿轮或对应齿轮的比率
9.
Array size control parameter index is out of range.
数组大小控制参数索引超出范围。
10.
(mathematics) calculation of the value of a function outside the range of known values.
（数学）对已知数值范围外的推导。
11.
On C Data Type and Number Range;
关于C的数据类型及数值范围的讨论
12.
A Study on the Premise of Cumulative Punishment- how to Determine the Scope of Plural Crimes
论数罪并罚的前提——数罪范围的确定
13.
The range of valid days is from 1 to 365. Please ensure a number is chosen within this range.
有效天数范围从1到365。请确认在此范围内现在一个数。
14.
Effect of Non-Parallel Combs of Capacitive Micro-Sensor on Reliable Operation Range
梳齿的不平行对电容式微机械传感器可靠工作范围的影响
15.
Results show that the saw-tooth signal amplitude oscillate within small amplitude through the calibration.
通过校准，锯齿波的幅值变化量可控制在很小范围内。
16.
Parameterized Design of Involute 3D Gear Based on VisualLISP
基于VisualLISP的渐开线三维齿轮范成参数化设计
17.
Number of copies and page range to print.
打印参数：设置打印拷贝数和页面范围的参数。
18.
Bad port range. Port ranges must be numerically non-decreasing.\0
错误的端口范围。端口范围必须是非递减的数字。\0