说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 电介质击穿
1.
dieletric breakdown test
绝缘击穿试验,电介质击穿试验
2.
solid dielectric breakdown due to treeing
固体电介质树枝化击穿
3.
The abrupt failure of an insulator or insulating medium to restrict the flow of current.
击穿绝缘体或绝缘介质突然无法制止电流通过
4.
Further Investigation of High Electrical Breakdown for Water Dielectric;
水介质耐高电压击穿技术的进一步研究
5.
Analysis of Dielectric Breakdown Mechanism in Micro Electrical Discharge Machining
微细电火花加工中极间介质击穿机理的研究
6.
Self-break water switches study under pulsed voltage in induction voltage adder
感应电压叠加器中水介质开关脉冲自击穿特性
7.
Optical Breakdown in Dielectrics;
透明介质光学击穿的理论与数值计算
8.
Numerical simulation of the breakdown on HPM dielectric surface
介质表面高功率微波击穿的数值模拟
9.
Study on Breakdown Experimental Device and Breakdown Performance of Liquid Dielectrics under Short-Pulsed Conditions;
快脉冲下液体介质击穿实验装置及击穿特性研究
10.
A state monitoring method of power cable based on the analysis of dielectric breakdown characteristic was presented.
在对绝缘介质击穿特性分析的基础上提出了一种电力电缆状态监测方法。
11.
This paper discusses the most suitable design of the homocentric ball capacitor on the condition that the maximum pressure endurance is limited and the puncture field is strong.
讨论了在限定最大耐压值及介质的击穿场强的情况下,同心球形电容器的最佳尺寸设计。
12.
Gate Dielectric Breakdown of Very-Deep Sub-micron n-channel Si-MOSFET;
超深亚微米n沟道Si-MOSFET中栅介质的击穿
13.
Studies on the Mechanism of Laser Induced Material Breakdown and the Formation of Plasma
激光致介质击穿产生等离子体的机理分析
14.
Vulcanized rubber--Test method for industrial frequency puncture voltage and dielectric strength
GB/T1695-1981硫化橡胶工频击穿介电强度和耐电压的测定方法
15.
This paper presents a new method for breakdown location on power cable insulation.
本文介绍了一种电力电缆绝缘击穿点定位的新方法。
16.
In the case of dielectric breakdown, a different type of acceleration occurs.
在介质击穿的情况下,出现了一种不同类型的加速。
17.
Experimental research on damage of dielectric materials under high power microwave in vacuum
真空中高功率微波下介质材料击穿破坏的实验研究
18.
Experimental research of AC breakdown voltage of evaporative coolant under boiled two-phase-flow condition
蒸发冷却介质两相流状态下工频击穿特性的实验研究