1.
Malfunction diagnosis analysis of a bracket mounting boss for engines
发动机支架安装凸台的断裂故障诊断分析
2.
The maximum stress of the framework occurred at the node of undersurface of the main hydraulic cylinder mounting boss.
机架最大应力值发生在主油缸安装凸台下表面的节点上。
3.
The slave unit is located at the ground stations.
附属装置安装在地面台。
4.
Verify Crankshaft—Camshaft Installation—Typical
验证曲轴—凸轮轴安装—典型的
5.
Install a new cam bolt, cam and new nut in the axlRe-align the reference marks.
在轴上安装新凸轮螺栓，凸轮和 新螺帽。重新校准参考标记。
6.
The camshaft also fits inside the block, except on overhead-cam engines( OHC).
除了顶置凸轮(HC)动机以外，凸轮轴都安装在气缸体里面。
7.
Rig up a donkey engine
安装一台辅助发动机。
8.
Microphones were set up in front of the speaker's stand.
讲台前安装了麦克风。
9.
Every lens has a mounting flange with which it is attached to the camera body.
每个透镜都有一个安装凸缘，依靠它才能把透镜安装到相机上。
10.
Two TDC (Top Dead Center) sensors are mounted at the rear of the single camshaft.
两个上死点的传感器安装在凸轮轴的后面。
11.
Inspection installation for antenna of radio console and measuring its insulation resistance.
组装报务台天线安装检查和绝缘测量。
12.
Anderson had a police scanner in his pickup.
安德森车上有一台警方安装的扫描器。
13.
No printer installed. Install a printer and try again.
未安装打印机。请安装一台打印机并重试。
14.
The following platform components failed to install and will need to be manually installed before setup can proceed:
无法安装以下平台组件，需要手动安装这些组件，然后才能继续安装:
15.
Be sure the dummy club of the bar put into the restrict slot followed by tightening the fastening screws of cover plate
一定要将芯棒的凸台装入限位槽内，拧紧盖板紧固螺丝。
16.
" Series of mounting sizes for vibration, shock and bump machine tables for electric and electronic products"
GB/T15480-1995电工电子产品用振动台、冲击台、碰撞台台面安装尺寸系列
17.
Sometimes the camshaft is fitted directly into the cylinder head and operates on the valves without rockers.
有时，凸轮轴直接安装在气缸盖上并且不用摇臂控制阀门工作。
18.
It is not advisable to attempt to replace camshaft bearings unless special removal and installation tools are available.
不要试图更换凸轮轴轴承，除非能够使用特殊的拆卸和安装工具。