1.
An Answer of Stress Field Strength Factors K for Near Cra ck_tip on Vorious Type Load;
一般载荷下裂纹尖端附近K的一种解法
2.
In general, the top surface of the beam is acted upon by transverse loads.
横向载荷作用一般认为在梁的顶面上。
3.
The formula calculation is in general smaller than that of loading test.
公式计算结果一般不大于载荷试验结果。
4.
General Solutions of the Circular Membrane under Composed Load in Large Deflection;
复合载荷下圆薄膜大挠度问题的一般解
5.
The dynamic loading resulting from blast, gusts of wind, or seismic forces is generally not harmonic.
由于冲击波，阵风或地震力所产生的动力荷载一般不是谐和的。
6.
Bases which carry horizontal load, for example under arches, are usually called abutments.
承受水平荷载的底座，例如拱底下的底座，一般称为拱座。
7.
Also, loads and control forces imposed by space vehicle guidance systems are generally small.
此外，由空间飞行器导引系统所产生的载荷与控制力一般是很小的。
8.
A general method for makingthe load spectrum is presented by using the load analysis of the engine supportframe of walking tractor HW--12.
并结合红卫-12型手扶拖拉机机架的载荷分析,给出了一般编谱方法。
9.
General Formula for Lateral Buckling Critical Force of Through Bowstring Tied Arch Bridge Without Transverse Beams
无横撑下承式系杆拱桥侧倾稳定临界荷载的一般公式
10.
The quantity that a car can hold.
车量荷载一车装载的量
11.
Bending stiffness of segment joint is a important parameter in shield tunnel structure design.
接缝抗弯刚度是装配式衬砌结构设计的重要参数,工程中一般是通过接头的荷载试验来确定。
12.
According to this procedure, general solutions of semi-infinite viscoelastic body under vertical and horizontalcircular uniform load are developed.
按此方法,本文导出了垂直和水平圆形均布荷载下半空间弹粘性体的一般解。
13.
Foundations are bases placed on the ground so as to spread a vertical load over it. Bases which carry horizontal load are usually called abutments.
基础是置于地基上的底座，其作用是扩散基础上面的垂直荷载。承受水平荷载的底座一般称为拱座。
14.
The amount that a wagon can hold.
载荷一辆运货车可以装载的量
15.
randomly-modulated carrier
随机调制载波(一般指噪声调制的载波)
16.
Typical droop is two cycles in frequency from no load to full load.
从空载到满载转速降一般为两赫兹。
17.
Iliad is generally fathered on Homer.
人们一般认为《伊利亚特》为荷马所著。
18.
KKW Analysis to a General Spherically Symmetric Charged Space
一般球对称荷电时空的KKW分析(英文)