1.
Springback Calculation of Multi-angle Panel during Bending
U形件多角拉弯成形时的应变及其对回弹影响
2.
Study of Multi-stage Deep Drawing for H-Bend Wave-guide;
H弯波导件多道次拉深成形技术的研究
3.
Effect of bending angle on hydroforming of curved hollow components
弯曲角度对弯曲轴线件内高压成形的影响分析
4.
capable of being shaped or bent or drawn out.
能够被塑成形状或者弯曲、拉长。
5.
Research on Profiles Stretch Bend Forming Process by PS2F Software
基于PS2F软件的型材拉弯成形工艺研究
6.
Numerical simulation of multi-pass roll forming process of anode plate
阳极板多道次辊弯成形过程数值模拟
7.
Experimental and Simulation Study on Discrete Die Stretch Bending Forming
离散模板料拉弯成形实验及数值模拟研究
8.
Stochastic Variability Analysis of Bending Angle in Sheet Metal Laser Forming Process
金属激光弯曲成形角度的随机变异性分析
9.
Simulation and Experimental Study on Residual Stresses for Multi-Stand Roll-Formed Sections
多道次辊弯成形冷弯型钢残余应力有限元仿真与实验研究
10.
Profile design for stretch bending die of extrusions considering springback
考虑弯曲回弹的拉弯模外形设计方法
11.
cause to assume a crooked or angular form.
引起弯曲或有角的形式。
12.
Analyse and Simulation on Bend Forming under the Modle of Forcedisplacement-Controlled MPF
力—位移分控模式多点弯曲成形分析与模拟
13.
Numerical simulation on the spring back of sheet metal after multi-step bending
板料多次弯曲成形回弹的数值模拟研究
14.
The temperature and the deformation fields of the forming process were calculated and the final bending angle was predicted.
计算了弯曲成形过程的温度场及变形场，预测了钢板的最终弯曲角度。
15.
the angle formed by two edges of a polyhedral angle.
多面体角的两个边所形成的角。
16.
This series pressing machine can be widely used in the technologies of drilling, losing materials, cutting, bending, shaping and light extension etc.
本系列压力机可广泛应用于冲孔、落料、切断、弯曲、成形、浅拉伸等工艺。
17.
He hooked his arm round her neck and pulled her head down.
他一只胳膊弯成钩形,搂在她的脖子上,把她的头拉低。
18.
It was concluded that failure of double clip reed was the result of local stress concentration and cracking at the sharp elbow of reed.
双卡簧片成形时弯角较尖锐并有明显裂纹是导致失效的原因。