1.
acceptable deviation of controlled variable
控制变量的容许偏差
2.
The difference between actual steady running tape speed, averaged over a period of 1 second or greater, and nominal tape speed, expressed as tolerance percentage on tape speed.
稳定在1秒钟以上的时间内的实际运行带速与正常带速之差，用带速的容许偏差的百分数表示。
3.
The permissible deviation from a specified value of a structural dimension, often expressed as a percent.
允许变量容差结构长度上允许存在的偏离某一既定标准的误差，常常用百分数来表示
4.
margin of error
最大容许误差;最大允许误差;误差界限;误差量
5.
color tolerance computer
颜色容许误差计算机
6.
bleed allowance
色浆渗化分线容许公差
7.
an unacceptable level of inaccuracy
误差达无法容许的程度.
8.
The film forgives errors in focusing.
这种胶卷容许调焦误差。
9.
The maximum allowable misalignment of the coupling is0.02 mm.
靠背轮找正的最大允许偏差为0.02毫米。
10.
Edge processing deviation should be allowed to meet the norms.
边缘加工允许偏差应符合规范的规定.
11.
Quality of electric energy supply-Admissible deviation of supply voltage
GB12325-1990电能质量供电电压允许偏差
12.
The net effect of biases on international comparisons is easily summarized.
偏差对国际比较的基本影响容易概括。
13.
Incentive Compatibility,Transaction Cost and the Policy Running Deviation
激励相容、交易成本与政策运行偏差
14.
Effect of capacitance deviation on the supercapacitor energy storage module and solutions
容量偏差对超级电容储能的影响及解决方案
15.
Deviation should be allowed to comply with the norms. The shear machine error should be allowed to meet the norms.
气割的允许偏差应符合规范的规定.机械剪切的允许偏差应符合规范的规定.
16.
maximum possible margin of population deviation
可容许的人口相差幅度上限
17.
" Hot-rolled beam steel-Dimensions, shape, weight and tolerances"
GB/T706-1988热轧工字钢尺寸、外形、重量及允许偏差
18.
" Hot-rolled channel steel-Dimensions, shape, weight and tolerances"
GB/T707-1988热轧槽钢尺寸、外形、重量及允许偏差