说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 拟紧
1.
X is quasi-compact (that is, every open covering of X has a finite sub-covering) .
X是拟紧的(即对于X的每个开覆盖都有一个有限子覆盖)。
2.
Finite Element Simulation of the Thin-wall Hydraulic Cylinder's Clamping Deformation
薄壁液压缸筒夹紧变形的有限元模拟
3.
Two-Level Tightly Concatenating Algorithm for Multiphysics Parallel Numerical Simulations
多物理并行数值模拟中的两层紧耦合联接算法
4.
Roller and Pushing-rod Locking Device for Cable Breaking and the Design of its Virtual Prototype
滚轮顶杆式断缆锁紧装置及其虚拟样机设计
5.
Numerical Simulation Study on Emergency Ventilation System in Subway Stations;
地铁车站紧急通风系统的数值模拟研究
6.
Simulation of Bond Stress in Short Cfst Column with Dumbbell-Shaped Section;
哑铃形截面钢管混凝土短柱紧箍力模拟
7.
The Numerical Simulation of Compact Toroids Acceleration with the Radiation Hydrodynamics Model;
紧凑等离子体环加速过程的辐射流体力学模拟
8.
Design of Compact Cyclotrons in Virtual Prototyping Environment;
虚拟样机环境下的紧凑型回旋加速器物理设计
9.
The Compact Sub-manifolds with Paralleled Mean Curvature Vector in Quasi Constant Curvature Riemannian Manifold;
局部对称拟常曲率空间中的紧致子流形
10.
Study on Cellular Automata Simulation of the Pedestrians' Urgent Evacuation Process
用元胞自动机模型模拟人员紧急疏散过程
11.
Soil water evaporation and its maths simulation under compaction stress condition
紧实胁迫条件下土壤水分的蒸发及数学模拟
12.
Flow simulation and analysis on FDF of compact spinning based on FLUENT
基于FLUENT的紧密纺大风机系统流场模拟与分析
13.
Numerical Simulation and Experimental Research on Compact Shaped Charge
紧凑型聚能装药的数值模拟及实验研究
14.
Application of Virtual Instrument in Automatic Crash Notification Technology
虚拟仪器在车辆紧急自动呼救技术领域的应用
15.
Reliability Evaluation Algorithm for Distributed Tightly-Coupled Virtual Private Networks
分布式紧耦合虚拟专用网可靠性计算方法
16.
The compact-type CIP method for the numerical simulation of the propagation of non-linear waves
紧致型CIP方法数值模拟非线性波的传播(英文)
17.
Compact LOD finite difference scheme for a kind of quasi-linear nerve conduction equation
一类拟线性神经传播方程的紧LOD差分格式
18.
Each datum, location pins, the number of the clamp sequence, check pin's name, the value of gap and tolerance need mark on checking fixture.
定位面,定位销,夹紧顺序,孔位测量销,模拟块偏置值及公差需有标识。