1.
An extended stored procedure did not set an out parameter data value.
扩展存储过程未设置输出参数数据值。
2.
Stored procedure "{0}" output parameter "{1}" missing.
缺少存储过程“{0}”输出参数“{1}”。
3.
Error executing extended stored procedure: Expecting an output parameter.
执行扩展存储过程时出错: 应有一个输出参数。
4.
The Measurement System of Acoustic Output for the Medical Ultrasonic Diagnostic Equipment;
医用超声诊断设备声输出参数测量系统
5.
Comprehensive Research on the Photovoltaic Maximum Power Point Tracking Based on Input Parameters or Output Parameters
基于输入-输出参数的光伏电池最大功率控制的比较
6.
"Configuration Manager: An output parameter was too small to hold all the data available.
"配置管理器: 某个输出参数太小，不能保存所有可用的数据。
7.
The {0} parameter of the {1}.{2} method must be an output-only parameter.
{1}.{2} 方法的 {0} 参数必须是只可输出的参数。
8.
Echo output on the screen or change echoing parameters.\0
在屏幕上回显输出或更改回显参数。\0
9.
Instrumental Varible Parameter Estimation for Multiple Input Signle Output Systems
多输入单输出系统的辅助变量参数估计
10.
Die-Casting Process Parameters Design System Based on a Multi-Input/Multi-Output GA-BP Neural Network
多输入/多输出GA-BP网络压铸工艺参数设计系统
11.
With estimating the numerator of the new SIMO model transfer function first and the common denominator later, the parameter estimation of the original SISO model is obtained.
再估计出这个新的单输入多输出系统的传递函数，最后得到原单输入单输出系统的模型参数。
12.
Added the 'u' modifier to printf/sprintf which prints unsigned longs.
增加了printf/sprintf的'u'参数来输出无符号的长整数
13.
Study on the Output Based Modal Parameter Identification;
基于输出响应的模态参数辨识方法研究
14.
Adaptive Output Tracking Control of Nonlinearly Parameterized System;
非线性参数化系统的自适应输出跟踪控制
15.
Study on Modal Parameter Identification Based on the Short-Time Output Signal
基于短时输出信号的模态参数识别方法研究
16.
Parameters Identification Method for Dual-rate Sampling Systems with Output Signal Quantization
输出信号量化的双率采样系统参数辨识方法
17.
Research on Soft-output Signal Detection and Parameters Design of Wireless MIMO Transmission Link
无线MIMO传输链路软输出信号检测与参数设计研究
18.
The conversion function identified by handler requires as its arguments pointers to the input and output strings, along with the length of each.
由句柄指定的转换函数请求输入、出字符中及它们的长度作为参数。