1.
Simulation Research on Effect of Edge Geometric Error of Valve Orifices to Spool Valve Characteristic;
阀口棱边几何误差对滑阀性能影响的仿真研究
2.
Controlling and Magneticabrasive Finishing of Valve Spool Edge Burr
阀芯棱边毛刺的控制与磁力研磨去除法
3.
Straightness measurement uncertainty evaluation for straight edge's working edge
刀口尺工作棱边直线度测量不确定度评估
4.
In this paper are described rational means and techniqueparameters of magnetic-abrasive finishing and grinding for removingthe valve spool edge burr and for keeping the edge sharp.
本文介绍了为去除阀芯棱边毛刺并保持锐边的适宜的磁力研磨和磨削的方法与工艺参数。
5.
The lever and weight is mounted on the right side of the valve when facing the inlet.
在面对这阀门的入口时,操纵杆和压铁安装在阀门的右边。
6.
Remove the relief valve cover bolts while holding the cover down.
边压住阀盖，边拆卸安全阀阀盖螺栓。
7.
ribbed top crew socks
棱纹统口水手式短袜
8.
Above-mentioned transducer can directly track the beveled sides, the edge of weld groove as well as the artificial tracking line (plastic tape).
传感器可直接跟踪焊接坡口的斜面或棱边,也可以跟踪人为跟踪线(塑料带).
9.
cornered piston ring
棱边精车过的活塞环, 修过角的活塞环
10.
Check valve tags are typically mounted on the rim of the cap.
止回阀标签通常安置在阀帽的边缘上。
11.
The curved edge at the junction of two intersecting vaults.
穹棱；穹棱肋在两交叉的穹顶相接处的呈曲线状的边缘
12.
The end flaps of the elastomeric seat should be flexed downward toward the valve I.D. as the body halves are being separated.
当阀体分开时，弹性阀体阀座的边缘应该朝向阀门内径弯曲。
13.
Application of an FEM-BEM method based on boundary edge elements to open boundary magnetostatic problems
边界棱边元FEM-BEM法在开域静磁场计算中的应用
14.
Edge-preserving Regularized Image Restoration Based on Detail Distribution Estimation by Wavelet
小波估计图像棱边分布的边缘保持规整化复原
15.
Clean all carbon deposits from the combustion chambers, valve ports, valve stems, valve stem guides and hea
从燃烧室、阀口、阀杆、阀导管和盖清洁所有的积碳。
16.
Stand clear of the regulator and valve outlet, while opening the valve.
开启阀门时，躲开调整器和阀门排气口。
17.
Test ports shall have internal check valve and be equipped with caps.
测试端口应该内置止回阀并配置阀盖。
18.
Research on Flow Characteristics of Typical Throttles in Water Hydraulic Servo Valve;
水压伺服阀典型阀口流动特性的研究