1.
USING THE METHOD OF INJECTING CURRENT FROM ADDITIONAL NODES FOR MODELING AND SIMULATION OF SSSC POWER FLOW CONTROLLER
利用附加节点注入电流法设计静止同步串联补偿器的潮流控制器
2.
A New Three Phase Power Flow Solution Based on Node Injection Sequence Currents;
基于序电流注入模型的三相潮流新算法
3.
Research and Application of the Algorithm of Load Flow Based on Current-Injection Model
电流注入型牛顿法潮流计算的研究及其应用
4.
Research on Earth Current Measurement Based on Signal Injection in Power Network;
基于信号注入法的电网接地电流检测技术研究
5.
Study on Measure Device for Capacitive Phase-to-earth Current in Distribution Network by Injecting Signals;
基于信号注入法的电网对地电容电流测量装置的研究
6.
The Research of Capacitance Current Automatic Measuring and Tuning Method Based on the Approach of Signal Injection;
基于信号注入法的电容电流自动检测与调谐方法的研究
7.
Testing for Analog Circuits Based on Pseudo-Random Current Injection Adopting Distance Classification;
采用距离分类法的伪随机电流注入模拟电路测试
8.
Cogging Torque Compensation for Flux-switching Permanent Magnet Motor Based on Current Harmonics Injection
基于电流谐波注入的磁通切换永磁电机定位力矩补偿方法
9.
Study on Fault-Locating Methods Based on Wavelet and Injecting Signal for Single-Phase Fault in the Neutral Indirectly Ground Power System;
小波及信号注入法定位小电流接地系统单相接地故障
10.
Study on Fault Line Selection Instruments of Small Current Grounding Network Based on Signal Injection and Transient Signal
信号注入与暂态信号方法结合的小电流接地选线装置
11.
Multi-Pulse Voltage Source Converter Based on DC Voltage Injection
基于直流电压注入的多脉动电压源换流器
12.
The Law Spirit of the Imperial Examinations Poured by the Fusion of Confucianism and Legalism;
儒法合流给科举制度注入的法律精神
13.
An Improved Current-Inpouring Mixer Based on CMOS Technology
基于CMOS工艺的改进型电流注入混频器
14.
The Nine-level Injection of Voltage Source Inverter on DSP
基于DSP的九级注入式电压源型变流器
15.
DC voltage control of single injection active power filter
单独注入式APF直流侧电压的稳定控制
16.
A New Topology of Three-Level Reinjection Current Source Converter in Parallel
一种新型并联三电平注入式电流型变换器拓扑
17.
Parallel topology of multilevel reinjection current source converter
并联多电平注入式电流源型变换器的新型拓扑
18.
The dry processes include spray drying, convective or pass injection, post-furnace injection of sodium compounds and furnace sorbent injection.
干法包括喷淋干燥、对流或顺流注入、钠化合物的炉后注入和炉内吸附物注入。