1.
Modeling and Simulation of Simple Guided Mortar Using Impulse Thruster Control
简易制导迫弹脉冲力控制建模与仿真
2.
Principle Analysis and Control for Pressure Impluse Test of Airplane Hydraulic System;
飞机液压系统压力脉冲试验的机理分析与控制
3.
The Optimal Control of the Nonlinear Impulsive System and Its Application;
非线性脉冲动力系统的最优控制及应用
4.
Parameter Identification, Optimal Control of the Impulsive Delay System and Their Application;
脉冲时滞动力系统的参数辨识，最优控制及应用
5.
Computational Analysis and Control Simulation of a Permanent Magent-Based Motor-Coil Repulsion Mechanism
音圈电动机式脉冲推力机构的计算与控制仿真
6.
burst controlled oscillator
短脉冲串控制振荡器
7.
pulse-controlled tube oscillator
脉冲控制电子管振荡器
8.
pulse temperature adjusting control board
脉冲温度调节控制板
9.
Sample control system (pulse control system)
采样控制系统(脉冲控制系统)
10.
Stability and Control of Impulsive Stochastic Systems and Impulsive Switched Systems;
随机脉冲系统和脉冲切换系统的稳定和控制
11.
Sensing and control on the keyhole condition during controlled pulse key-holing plasma arc welding
PAW受控脉冲穿孔状态的检测与控制
12.
The performance of cleaning pipe can be controled through the detected high frequency barometric pulse signal with pressure sensors.
通过压力传感器所检测高频气压脉冲信号可以实现对清洗的控制。
13.
Study on Emulation and Experiment of the Impulse Torques Control of Two link Flexible Manipulators
柔性双连杆机械臂脉冲力矩控制的数值仿真和实验研究
14.
APPLICATION RESEARCH OF FIELDBUS TECHNOLOGY IN PULSE NITROGENOUS CONVEYING CONTROL SYSTEM;
现场总线技术在氮保护脉冲气力输送控制系统中的应用研究
15.
Design and Lmplementation of the Electrical Control Systems for the Deburring Pulse Electrolysis Equipment in the Pressure Chamber of Needle;
针阀体压力室脉冲电解去毛刺设备的电气控制系统设计与实现
16.
Robust Synchronization of Complex Delayed Dynamical Networks Based on Impulsive Control
基于脉冲控制下的复杂时滞动力网络的鲁棒同步
17.
Position control of d. c. motors has been done by means of pulse width modulation.
直流电机位置用脉冲宽度调制法控制。
18.
Research on Circuit Control System of Optical Fibre Pulse Accumulation;
光纤脉冲堆积器电路控制系统的研制