1.
Research on the Stimulated Raman Spectrum in Submicro-Diameter Fiber
亚微米直径光纤的受激拉曼谱特性研究
2.
Fabrication of Submicro-diameter Fiber and Stimulated Raman Scattering Effect in it;
亚微米直径光纤的制造及其中的受激拉曼散射效应
3.
Investigation on Micro-defects in Large-diameter CZSi Crystal Used for Sub-micro IC;
深亚微米级集成电路用大直径CZSi单晶中微缺陷的研究
4.
Microarc Oxidation Coating of the Sub-Micron Holes
亚微米级孔径微弧氧化膜层工艺研究
5.
One micron is a thousandth of a millimeter: a pinhead is about a millimeter across.
一微米等于千分之一毫米。 针头直径大约一毫米。
6.
Stage 3: >=400 microns in diameter, pseudooperculum.
直径大于400微米(裂孔),假性包盖。
7.
Rod-shaped bacteria are usually from two to four microns long, while rounded ones are generally one micron in diameter.
棒状细菌通常有2-4微米长,而圆形细菌的直径一般只有1微米。
8.
Studies on the Size Distribution and Polycyclic Aromatic Hydrocarbon Contents of Submicron Aerosols;
亚微米气溶胶的粒径谱及其中多环芳烃的研究
9.
DROPLET SIZING OF SUBMICRON EMULSIONS BY ULTRASONIC ATTENUATION AND VELOCITY SPECTRA
超声衰减和速度谱测量亚微米乳液的粒径
10.
Particulate matter includes particles from molecular size to greater than 10Mm in diameter.
微粒物质包括从分子大小到直径大于10微米的粒子。
11.
The size of tumors ranged from 7 to 19 cm ( mean 12.5 cm) in diameter.
肿瘤直径7-19厘米,平均直径12.5厘米。
12.
Spot diameters of just a few thousands of an inch can readily be attained with convenient short focal length lenses.
用普通的短焦距透镜不难得到直径只有几十微米的光点。
13.
Stage 3: >=400 microns in diameter, operculated, traction released.
裂孔直径400微米以上,有盖,(玻璃体)对网膜的牵引解除。
14.
Stage 2: Full thickness macular hole, can opener tear or pseudooperculum, <400 micorns in diameter.
全层黄斑裂孔,可为开罐式撕开或假性包盖,裂孔直径小于400微米。
15.
STUDY ON THE POSITIONING TECHNOLOGY OF LONG DISTANCE AND SUBMICROMETER ACCURACY LASER DIRECT WRITING DEVICE;
大行程亚微米精度激光直写设备定位技术的研究
16.
The bolt has a diameter of 1cm.
螺栓直径为1厘米。
17.
The huge round urn of all Acrylic glass is 11 meters in diameter and 13 meters in depth, with water body totaled 1000 metric tons.
全部用亚克力玻璃筑成的大圆缸,直径有11米,水深13米,高达三层楼体,水体达1000吨。
18.
To get its prototype, the team had to create silicon pillars each roughly300 nanometers wide and spaced about two microns apart.
为了制作原型产品,团队必须制作出直径约300奈米,彼此间隔约2微米的矽柱。