1.
Modeling & Simulation, Design Evaluation of the Two-axes Position Mechanism for Satellite Antennas Based on the Virtual Prototype Technology;
基于虚拟样机技术的卫星天线双轴定位机构建模、仿真与设计评估
2.
Research on parameters of double axle double eccentricity roll cutting typed cut to length shearing machine
双轴双偏心滚切式定尺剪机构参数的研究
3.
Improve on Dial Orientation Block of Carrousel Double Mandrel Sleeve Tension Reel
卡罗塞尔双芯轴卷取机转盘定位挡块的改进
4.
A Method of Determining the Relative Winding Axises Position of Dual-Stator Permanent Magnet Electrical Machine
双定子永磁电机内外定子绕组相轴相对位置确定方法
5.
Finite Element Analysis and Optimization of Three-axis Orientation Platform
三轴定位平台随动机构的有限元分析及优化
6.
Research on Machine Retrofitting of Double-Station Horizontal Machining Center and Spindle PMC Porgrame;
双工位卧式加工中心机械结构的技术改造及主轴PMC控制程序编制
7.
The application of the double-gyration device on LAMOST fiber positioning unit is introduced.
介绍了双回转机构在LAMOST光纤定位单元中的应用。
8.
Study on Precision Positioning Mechanism Driven by PZT Bimorph
压电双晶片作为驱动的精密定位机构研究
9.
external phasing gears
(单纯旋转发动机的) 外轴式相位机构
10.
The Study on Mechanism Analysis and Locating System with Binocular Cameras of Tomato Harvesting Manipulator;
番茄收获机械手机构分析及双目定位系统的研究
11.
Duplex-bit eight-axis CNC heat treatment system design
双工位8轴热处理机床数控系统的开发设计
12.
Analysis on the TSI positioning optimization of 1 000 MW steam turbine
1000MW汽轮机TSI调整轴系定位法优化分析
13.
The Study of Random Damage Evolution Low of Concrete Material under Two-Axial Stress;
混凝土在双轴作用下随机损伤本构关系研究
14.
Motion Behavior and Simulation Analysis on Coaxial Out-put Impulse Mechanism
同轴双输出脉冲发生机构运动特性与仿真分析
15.
STUDY ON BIREFRINGENCE OF BIAXIALLY HOT-STRETCHED ACRYLICS BY USING CONVERGENT POLARIZED LIGHT
用会聚偏振光测定双轴热拉伸有机玻璃板的双折射值的研究
16.
A new structure for fixing the bearing bush of the connecting lever in a crankshaft press is introduced.
针对曲轴压力机连杆上轴瓦的固定问题，介绍了一种新的固定结构。
17.
The stochastic damage constitutional law models of concrete under uniaxial tension, uniaxial compression and biaxial tension compression combination are established.
建立了混凝土单轴受拉、轴受压与双轴拉压组合条件下的随机损伤本构关系模型.
18.
Bushings: Furnishes shaft support at three locations for positive shaft alignment and actuator support.
衬套:在三个位置上配置轴支撑,有利于轴校直和执行机构的支撑。