1.
Parametric Finite Element Simulation and Optimization of Plastic T_Tube's Forming Bulging Process;
塑料三通管挤胀成型过程的参数化模拟及优化
2.
Table of universal wall thickness of thermoplastics pipe
GB/T10798-1989热塑性塑料管材通用壁厚表
3.
Plastic Limit Load Analysis of the Piping Branch Junctions with Defect Pitting Corrosion
含点蚀缺陷三通管塑性极限载荷分析
4.
All the plastics pipe system is a good example of the latter. This uses a plastic service pipe instead of the usual steel or copper pipe.
后者的最好例子是所有管路系统采用塑料管,用塑料管来代替通常用的钢管和铜管。
5.
Design of the Extruding Die for Compound Triple-Layer Plastic Pipe by Two Extruding Machines
两台挤出机共挤复合三层塑料管材的机头设计
6.
drip irrigation; trickle irrigation: The application of water to the soil through small orifices in plastic pipelines.
滴灌:通过塑料管道的小孔对土壤进行浇灌。
7.
The new winter ventilation system consisted of a perforated plastic tube.
新的冬季通风系统由带孔的塑料管组成。
8.
A Finite Element Analysis for Plastic Limit Load of Welded Piping Branch Junctions;
焊制三通管件塑性极限载荷的有限元分析
9.
Research in the Theory & Experiment of Plastic Bulging Forming and Finite Elementanalysis for T_Tube's Forming Bulging Process;
塑料挤胀成型过程的理论和实验研究及塑料三通挤胀成型过程的有限元分析
10.
two metres of copper, plastic, etc tubing
两米铜管、 塑料管等.
11.
sewing machine with 3-drawers and plastic flat cover
三斗塑料平板缝纫机
12.
THE DISPOSAL OF KEY PROBLEMS IN 3-D RIGID PLASTIC FEM SIMULATION OF THE EXTRUDING-BULGING PROCESS OF TEE TUBES
三通管挤胀成形过程三维刚塑性有限元模拟中关键问题处理
13.
The plastic capsule was transparent all the way round.
那个塑料小盒通体透明。
14.
Stress Strength Judgment to the Straight Tee of Side Inlet Feed
侧线进料三通接管结构应力强度评定
15.
general rules for tests for thermal ageing properties of thermoplastics in the form of sheet by means of ovens
热塑性塑料热老化试验法通则(烘箱法)
16.
EMS, plastic injection, metal stamping, diodes and transistors, speaker drivers, wire and harnesses.
音响、模具、塑料及五金、二、三极管、可变电阻、扬声器单元、电线及多组线。
17.
3D numerical simulation of fluid flow and heat transfer enhancement in plastic elliptic oblique teeth flat strip tube
塑料斜齿平带管内三维流动及强化传热的数值模拟
18.
reclaimed plastics drain pipe panel for road
公路用再生塑料排管板