1.
As for the selection of throttle orifice, methods for calculating the number of orifice stages, pressure difference and orifice diameter are described as well.
介绍了选择节流孔板的计算方法,包括节流孔板级数、力差和孔径的计算。
2.
Analysis of Flow Field Characteristic of Orifice and Study on Damping Grooves in Hydraulic Pump Valve Plate
节流孔流场特性分析及液压泵减振槽研究
3.
Investigation on magnetic oxide iron depositionof throttle orifice plate in once-through boiler water wall
直流锅炉水冷壁节流孔板磁性氧化铁沉积探讨
4.
Changing throttle hole area has not influence on winding current,electromagnetism valve lift.
改变节流孔面积对线圈电流、电磁阀升程没有影响；
5.
Tube Explosion Analysis and Prevention of USC Water Wall Throttle Orifice
超超临界机组水冷壁节流孔板结垢爆管分析及预防
6.
Analysis and prevention of sulfate scale on throttle orifices for water walls of USC vertical tube coil once-through boilers
超超临界垂直管圈直流炉水冷壁节流孔圈垢物聚结原因分析及预防
7.
The high ratio of diaphragm to orifice provides excellent performance and stability at low reduced pressure.
在低减压情况下，隔膜到节流孔的高控制比具有卓越的性能和稳定性。
8.
orificing the coolant
对冷却剂加孔板节流
9.
a hand operated lever that controls the throttle valve.
控制节流闸流量的手孔杠杆。
10.
Mount restrictor bar into the restrictor bar groove of upper die, mount adjusting bolt for restrictor bar into the bolt hole in the restrictor bar, then mount lower press block, upper press block.
在上模节流棒槽内装入节流棒，将节流棒调节螺栓装配进节流棒的螺丝孔中，再装配上压块。
11.
Head Meter Design for Test-bed of Heavy Hydraulic Cycle Compressor;
液环压缩机实验台孔板节流装置的设计
12.
Cranial Drilling and Catheter Drainage in Treatment of Hypertensive Cerebral Hemorrhage in Basal Ganglia
颅骨钻孔置管引流治疗基底节区高血压脑出血
13.
Optimization design and experimental model analysis of complex throttle injection with small apertures spray muffler
节流降压-小孔喷注消声器优化设计与模态分析
14.
" Measurement of fluid flow by means of orifice plates, nozzles and Venturi tubes inserted in circular cross-section conduits running full"
GB/T2624-1993流量测量节流装置用孔板、喷嘴和文丘里管测量充满圆管的流体流量
15.
Analysis of Orifice Compensated Mode Affecting Aerostatic Bearings Working Stiffness
小孔节流方式对气体静压轴承工作刚度影响的分析
16.
Analysis of Dynamic Characteristics of Aerostatic Bearing with Orifice Restrictors and Corresponding Rotor-Bearing System;
小孔节流静压气浮轴承—转子系统动力学特性研究
17.
Particle Flow Code Numerical Simulation Of Failure Around a Circular Opening In Jointed Rock Mass
含孔洞节理岩体损伤破坏过程的颗粒流数值模拟
18.
The Design of Orifice Compensated Hydrostatic Bearing on Over Loading Crankshaft of Oxygen Compressor
氧气压缩机重载荷曲轴用小孔节流静压轴承的设计