1.
Investigation of Quantum Properties and Quantum Measurement of Optical Parametric Process
光学参量过程的量子特性与量子测量研究
2.
The pump wave decays into an ion Bernstein wave or a lower hybrid wave is most probable.
泵波参量衰变成离子伯恩斯坦模或低杂波是最可能的参量过程。
3.
Theoretical and Experimental Investigation on the Generation of Squeezing Light Using Optical Parametric Process in PPKTP Crystal;
PPKTP晶体光学参量过程产生压缩光的理论和实验研究
4.
A cursor variable cannot be used as a parameter to a remote procedure call.
游标变量不能用作远程过程调用的参数。
5.
The Quality Game Analysis of the Principal Players of Construction Project;
工程项目施工过程主要参与方质量博弈分析
6.
Research on the Parameters' Soft Sensing and Synthetic Optimizing Control of Grinding Process;
磨矿过程参数软测量与综合优化控制的研究
7.
Numerical Simulation of Engine Con-rod Fracture Splitting Process and Analysis on Effect Factors
发动机连杆裂解过程数值模拟及裂解参量分析
8.
Schemes for Realizing Parametric Down-conversions in Cavity Quantum Electrodynamics
基于腔QED来实现参量下转换过程的方案
9.
DEVELOPMENT OF SOFTWARE SENSORS FOR ON-LINE MEASUREMENT OF GSH FERMENTATION PROCESS PARAMETERS
酵母发酵生产谷胱甘肽过程参数的在线软测量
10.
Parameter Optimization of Soft Sensor Model of Succinic Acid Fermentation Process
丁二酸发酵过程软测量模型的参数优化研究
11.
Abstract: Good order parameter can reflect the symmetry changes perfectly during phase transition.
文摘:好的序参量能很好地反映相变过程中对称性的变化。
12.
The electrons that participate in the conduction process are termed free electrons, which have energies greater than the Fermi energy.
参与导电过程的电子，我们称之为自由电子，其能量高于费米能级。
13.
A scalar function that shows whether or not the procedure has returned a cursor and result set for a given parameter
一个标量函数，显示过程是否已为给定的参数返回游标或结果集
14.
In PL / 1, an expression and argument list that is part of a procedure reference.
pl／1语言中的一个表达式及自变量表，是过程参照的一部分。
15.
The number of packets that have been sent by the packet scheduler at a rate which exceeded the flow parameters
用超过流量参数的速率发送数据包计划程序的数据包数目
16.
The number of packets that have entered the packet scheduler at a rate which exceeded the flow parameters
用超过流量参数的速率进入数据包计划程序的数据包数目
17.
For this reason, must optimize the parameter and control impurity.
为此，在球磨过程中，必须优化参数及控制杂质的含量。
18.
Record and monitor the process parameters and product properties, which may affect the suitability of quality.
对影响质量适宜的过程参数和产品特性进行记录和监控.