1.
Anodizing of aluminium and its alloys--Assessment of quality of sealed anodic oxide coatings by measurement of the loss of mass after immersion in phosphoric-chromic acid solution
GB/T14952.1-1994铝及铝合金阳极氧化阳极氧化膜的封孔质量评定磷-铬酸法
2.
Anodizing of aluminium and its alloys--Assessment of sealing quality by measurement of the loss of mass after immersion in acid solution
GB/T14952.2-1994铝及铝合金阳极氧化阳极氧化膜的封孔质量评定酸浸法
3.
Anodizing of aluminium and its alloys-Determination of quality of sealed anodic oxide coatings-Admittance method
GB/T11110-1989铝及铝合金阳极氧化阳极氧化膜的封孔质量的测定方法导纳法
4.
Research on Quality of Drilled Holes for Cast-in-Place Piles in Shanghai District;
上海地区钻孔灌注桩成孔质量的研究
5.
any substance used to seal joints or fill cracks in a porous surface.
任何用于密封接口或填充多孔表面空隙的物质。
6.
A Laboratory Study on Durability of Foam Plug Created in Porous Media
泡沫在多孔介质中封堵有效期实验研究
7.
Macroporous Resin Separation and HPLC Method for Determination of Entrapment Efficiency of Sesamin Liposome
HPLC-大孔树脂法测定芝麻素脂质体包封率
8.
Analysis on the gas pressure measurement result revision on the basis of gas loss quantity before bore being sealed
基于封孔前瓦斯损失量的测压结果修正分析
9.
Experimental investigation on discharge coefficient of jet impingement holes within semi-confined channel
半封闭通道射流冲击孔流量系数的实验
10.
Planting bar used syringes from the bottom of the hole to put adequate amounts of external uniform adhesive filling injection hole, pay attention not to air hole inclose.
使用植筋注射器从孔底向外均匀地把适量胶粘剂填注孔内,注意不要将空气封入孔内.
11.
Post pressure grouting of borehole cast-in-situ pile bottom and its quality control
钻孔灌注桩孔底后压浆施工工艺及质量控制
12.
Quality Questions Study of Diesel Engine Cylinder Block Bore and Cylinder Bore Machining;
柴油机机体缸孔及缸套孔加工质量问题探讨
13.
Pile-forming Construction Quality Control of Bored Pile of Highway Brige
公路桥梁钻孔灌注桩成孔施工的质量控制
14.
On the quality problems in drilling
浅谈如何防治钻孔灌注桩钻孔施工时质量通病
15.
Appearance quality for reciprocating rubber seals
GB/T15325-1994往复运动橡胶密封圈外观质量
16.
Appearance quality for rotary shaft lip seals
GB/T15326-1994旋转轴唇形密封圈外观质量
17.
KJDT Monomer Shore Airproof Quality Measure System;
KJDT单体支柱密封质量监测系统
18.
Specialty of Seals Quality System and Opportunities to Improve
密封件质量体系的特殊性和解决方案