1.
Mathematical Model to Schedule Dieless Drawing Speed for Tapered Tubes
确定锥形管无模拉伸速度制度的数学模型
2.
Dieless Drawing Technique for Making Tapered Pipe With Square Cross Section
一种新型的锥形方管无模拉伸成形工艺
3.
Predicting Model and Influencing Factors Analysis of Tensile Strength of PP/Inorganic Particles Composites
PP/无机粒子复合材料拉伸强度的预测模型及影响因素分析
4.
Analysis of the mechanical behavior of polymer in an amorphous state under uniaxial extension condition through atomistic modeling
原子模型分析无定型聚合物在单轴拉伸下的机械行为
5.
To shape or elongate(a wire, for example)by pulling through dies.
拉伸通过印模使（如金属线）成形或伸长
6.
A minimum of 3 years experience in stamping design.
3年以上冲压与拉伸模具的设计经验。
7.
The Tensile Breaking Progress Simulation and Strength Prediction of Woven Fabric;
机织物拉伸断裂过程模拟及强度预测
8.
CAI Software Development on Measuring Young s Modulus of Tinsel by Pulling and Stretching Method;
拉伸法测金属丝杨氏模量CAI课件开发
9.
Application of AUTOFORM4.1 Software in Automobile Cover Drawing Die
AUTOFORM4.1在汽车覆盖件拉伸模设计中的应用
10.
Design of Progressive Drawing Die for the Mobile Phone Accessory Threading Set
手机饰品穿线套连续拉伸级进模设计
11.
Design of Blanking-Drawing-Trimming Compound Die for the Water-Containing Plate
接水盘落料-拉伸-切边复合模设计
12.
Design of Progressive Die with Side Notching and Horizontal Blanking for Drawing Part
侧冲缺口-横向冲切落料拉伸级进模
13.
Research on the Surface Intensifying Treatment of Drawing Mould with Material QT600-3
QT600-3材料的拉伸模表面强化处理研究
14.
Numerical Simulation of Breadthwise Stretching Process of Biaxially Oriented Plastics Film;
双向拉伸塑料薄膜横拉成型的数值模拟研究
15.
The elongation of a body in tension above its no-load length is directly proportional to the stretching force.
物体在拉伸状态下，其伸长量（相对于无负荷时的长度）与拉伸力成正比。
16.
Necking and Fracture of Oxygen-Free high Conductive Copper Bars Subjected to high Strain Rate Tension
高导无氧铜杆高应变率拉伸下的颈缩与断裂
17.
The mathematical analysis of multi-zone roller stretching for untwisted fiber sheet
无捻纤维片多区罗拉牵伸的数学分析(英文)
18.
ericessen test
埃留伸薄板拉伸试验