说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 热扰动
1.
Analysis in Temperature Field and Thermal Response Around U-Type Vertical Ground Heat Exchanger of Ground Source Heat Pump;
土壤源热泵垂直U型埋管温度场及热扰动分析
2.
South Tropical Disturbance
南热带扰动 -木星
3.
A Study on Adiabatic Transient Behavior of Thrust Bearing under Dynamic Operating Load
载荷扰动下滑动推力轴承绝热瞬态过程分析
4.
Study on the Mechanism of Early-Summer Rainstorms in Southern China Triggered by Tropical Disturbances;
热带扰动引发华南前汛期暴雨的机理研究
5.
The Application of Fuzzy PID Control Method on Reheat Steam Temperature Based Perturbation Analysis;
基于扰动分析的再热汽温模糊PID控制方法研究
6.
Continuous Dependence on Spatial Geometry for Low Temperature Heat Conduction;
低温热传导方程组解对区域扰动的连续依赖性
7.
Numerical simulation on flow and heat transfer in rotating channel with small spacing pin-fin arrays
旋转对小间距扰流柱通道内的流动换热影响
8.
Investigation of Lateral Jet Interaction Test for Different Media
冷/热喷流对飞行器气动特性干扰实验研究
9.
The anti-interference technology of thermocouple channel used in rocket engine test system
火箭发动机测试系统热电偶通路抗干扰技术
10.
Numerical simulation on flow and heat transfer in channel with small spacing short pin-fin arrays
小间距梯形扰流柱通道内的流动换热数值计算
11.
Thermal Transient Behavior of Thrust Bearing under Step Applied Load
阶跃载荷扰动条件下推力轴承热瞬态过程研究
12.
Effect of Adiabatic Dust Charge Fluctuation On Three-Dimensional Solitary Waves In Inhomogeneous Dusty Plasmas
绝热电荷扰动对非均匀热尘埃等离子体中三维孤波的影响
13.
Study on the thermal insulation transient process of radial sliding bearing under the turbulence of stepped loading
阶跃载荷扰动下径向滑动轴承绝热瞬态过程研究
14.
Part warms the atmosphere, creating winds and other disturbances.
另一部分晒热了大气,形成风及其他大气扰动现象。
15.
Disturbances in the recirculating flow regime can produce related variations in the heat release rate in the primary mixing region.
回流区域内的扰动可使主要混合区内热量释放发生相应的变化。
16.
Investigation of Flow and Heat Transfer in a Pin-Fin Trapezoidal Duct;
有弦向出流及扰流柱排的梯形通道内的流动与换热研究
17.
A Study on the Forecasting Performance and Ensemble Perturbation of Tropical Cyclone Track Using GRAPES_TCM;
基于GRAPES_TCM的热带气旋路径预报性能分析及集合扰动初步研究
18.
Prediction of Adiabatic Shear in High Speed Machining Based on Linear Pertubation Analysis
基于线性扰动分析的高速切削过程绝热剪切预测研究