说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 最小厚度
1.
minimum cover of reinforcement
钢筋保护层的最小厚度
2.
minimum thickness of neck
缩颈的最小直径;颈部的最小厚度;颈部的最小厚度
3.
Minimum thicknesses in rim and centre of lens
GB/T1205-1975透镜边缘及中心最小厚度
4.
Research on Methods for Testing Minimum Thickness of Cement Soil Cut-off Wall Body
水泥土截渗墙墙体最小厚度测试方法研究
5.
Minmum thickness of sheath and maximum overall of cable refer to Table 3.
终端电缆的护套最小厚度和电缆最大外径见表2。
6.
The function's proceeding every kind of degree of hardness parameter converts automatically mutually, discriminating to try an environment for the minimum thickness experiments with the measurement temperature.
该机能进行各种硬度参数相互自动换算,鉴别试件最小厚度和测定试验的环境温度。
7.
Study on Rock Cover of Subsea Tunnel in Jointed Rock Mass;
裂隙岩体海底隧道最小岩石覆盖厚度研究
8.
Analysis,Calculation and Investigation of Minimus Film Thickness of Rolling Bearing
滚动轴承最小油膜厚度的分析计算研究
9.
LOWEST OIL FILM THICKNESS ANALYSIS OF AEAR DRIVE & IMPROVE IUBRICATION MEASURE
齿轮传动最小油膜厚度分析及改善润滑的措施
10.
Simplification and application of calculation formula for linear contact minimum lubricant film thickness
线接触最小油膜厚度计算公式的简化及应用
11.
Weighted function method for minimum rock cover thickness of subsea tunnel
海底隧道最小岩石覆盖厚度的权函数法
12.
maximum width and thickness of the pad
荚的最大宽度及厚度
13.
Minimum Chip Thickness in Orthogonal Micro-cutting Based on Plasticity Strain Gradient Theory
基于应变梯度理论的正交微车削中最小切削厚度预测
14.
As the film thickness increases, both the maximum length and maximum width of the rectangle-shaped domains increase first, and then they decrease steadily.
带状结构中畴块的最大长度和最大宽度均先随薄膜厚度的增加而增大,随后稳定变小。
15.
16 tool holder must be designed to provide a minimum of 4” of steel thickness on all sides of cavity imprint.
模座必须设计成:在型腔印痕整侧提供最小4”的钢材厚度。
16.
Research on the Minimum Rock Cover Thickness of Underwater Tunnel in Alternating Layers of Hard and Soft Rocks;
软硬岩交互地层水下隧道最小岩石覆盖层厚度研究
17.
Application on Calculation Method of Smallest Support Thickness in Soft Stratum and Large Cross-section Shaft and Tunnel
松软地层大断面井巷最小支护厚度计算方法及应用
18.
Insulation thickness, sheath thickness and maximum overall diameter.
补偿导线的线芯绝缘厚度,护套厚度及最大外径。