1.
The Effect of Transverse Cracks on Rigidity and Strength of CRCP Pavement;
横向裂缝对CRCP路面刚度和强度的影响
2.
Coupling Research on Tribology, Stiffness and Strength of Crankshaft-bearing System;
曲轴—轴承系统摩擦学、刚度和强度的耦合研究
3.
Improvement Research of Analysis Method of Stiffness and Strength for Engine Hood on a Passenger Car for Engine Hood on a Passenger Car;
某轿车发动机罩刚度和强度分析方法改进研究
4.
The structural strength and flexural rigidity of the fuselage main frame are computed and verified by CAE system software and the results are analyzed.
应用CAE系统软件计算承力密封框的刚度和强度,并分析了计算结果。
5.
Coupling Researches on Dynamics Tribology Stiffness and Strength in the Crankshaft-Bearing System of Internal Combustion Engine;
内燃机曲轴—轴承系统动力学摩擦学刚度和强度耦合研究
6.
Prediction of the stiffness and strength of 3D five-directional braided composites based on the bridge model
基于桥联模型预报三维五向编织复合材料的刚度和强度
7.
The results show that the stress intensity and stiffness are enough.
结果表明，刚架结构的强度和刚度是足够的。
8.
Analysis on Intensity and Stiffness of Frame Based on ANSYS;
基于ANSYS的车架强度和刚度分析
9.
Finite element analysis about the intensity and the stiffness of the elliptical manhole
椭圆形人孔强度和刚度的有限元分析
10.
Influence of diamond concentration,grit size and hardness on the performance of diamond saw blade
金刚石浓度、粒度和强度对锯片切割性能的影响
11.
Solids have rigidity, fixfed shape, and mechanical strength.
固体具有刚性、一定的形状和机械强度。
12.
3D Finite Element Analysis of Stiffness and strength of Main Bearing Cap of Internal combustion Engine
内燃机主轴承盖强度和刚度的三维有限元分析
13.
Analysis on Strength and Stiffness for LDP of ESJL Based on FEM;
电动架车机升降筒强度和刚度的有限元分析
14.
Finite Element Calculation for Strength and Stiffness of Gas Turbing Seat
燃气轮机压气基座强度和刚度的有限元计算
15.
Experimental Study of Inelastic Buckling Strength and Stiffness Requirements for Longitudinally Stiffened Panels
纵向加劲板非弹性抗弯强度和刚度试验研究
16.
Research for the Seismic Behavior of the Structural System with Limited Stiffness Outrigger and with Rigid Outrigger;
有限刚度加强层和刚性加强层结构体系的抗震性能研究
17.
Ribs are sometimes add to the webs of castings to give greater strength and rigidity.
有时在铸件的腹板上加上肋条，以增强其强度和刚度。
18.
In addition to the strength and rigidity, the dynamic properties of machine tool spindle should be considered.
机床主轴的设计除了要考虑其强度和刚度外,尚须考虑其动态特性。