1.
The Length of Limit Cycles For Fuzzy Bidirectional Associative Memories and Algorithms to Compute the Period Index of Fuzzy Matrix;
模糊双向联想记忆网络的极限环长度及模糊矩阵周期算法
2.
determination of the long-term ultimate bending strain and calculation of the long-term ultimate relative ring deflection, both under wet conditions
潮湿条件下长期环状弯曲应变和长期环形偏转的极限测定
3.
Analysis of loop removal from finite-length LDPC codes
有限长低密度奇偶校验码的去环分析
4.
The Radiation Field of Finite Length Dipole Antenna on Layer Medium
层状媒质上有限长度偶极天线的辐射场
5.
The greatest or utmost degree or point.
极端，极度最大或极限的程度或终点
6.
Ambient air temperature and humidity may also have an effect on the flammable limits.
周围环境的空气温度和湿度也对可燃极限有影响。
7.
The Limit Cycle of a Kind of Kolmogorov s System;
一类Kolmogorov系统的极限环
8.
The variation of ultimate tensile strength with length for amosite crocidolite, chrysotile is shown in Table 2.10.
铁石棉，青石棉和温石棉的极限抗拉强度随长度的变化情况见表2．10．
9.
Economic Growth: The Theoretical Debate on the Issue of Resource, Env ironment and Growth Limit and the Choice Faced by Human Being;
经济增长:资源、环境和极限问题的理论争论与人类面临的选择
10.
Limit Cycles Near Homoclinic and Double Homoclinic Loops;
同宿环及双同宿环附近极限环的个数
11.
Determination of time-temperature limits of plastics after exposure to prolonged action of heat
GB/T7142-1986塑料长期受热作用后的时间-温度极限的测定
12.
The emphasis on the minimum nozzle length was carried to the limit with the design of nozzle with sharpedged throats.
强调最小喷管长度转向采用锐边喉管道的喷管设计的极限值。
13.
Research of Limited Slope Grade and Length of Rur Road Based on Driver s Psychological and Physiological Reflection;
基于驾驶员心生理反应的山区双车道公路极限坡度坡长研究
14.
Forecasting Precision Analysis of Unequal-Step Gray Model GM(1,1)in Forecasting the Ultimate Bearing Capacity of Single Pile
单桩极限承载力非等步长灰色GM(1,1)模型预测精度分析
15.
Study and application of design method for expansion liner length under limiting operational condition
极限工况条件下膨胀衬管长度设计方法研究与应用
16.
Conclusion Within the elastic limit of the material,the relation between the retention of gold alloy clasp and the depth of abutment undercut showed positive correlation.
结论在卡环弹性极限内,金合金卡环固位力与卡环臂进入基牙倒凹的深度成正比。
17.
limiting lateral acceleration test
极限侧向加速度试验
18.
maximum limit of speed setting
速度调节的最大极限