1.
Research on Automatic Measurement and Control System of Solid Temperature Relay;
固体温度继电器自动测控系统的研究
2.
Again, if there is excessive relative sliding the fluid will become too hot to solidify.
液体温度太高以致也不能固化。
3.
The Hardware Design of Solid Laser Temperature Control System;
固体激光器温度控制系统的硬件设计
4.
Concrete solidification temperature changes in the process of analysis
大体积混凝土凝固过程中的温度控制
5.
Analysis on the temperature and stress of the solid rocket motor in sea environmental temperature
海洋环境温度下固体火箭发动机的温度和应力分析
6.
A heat balance gives the temperature of solids at any time.
从热量衡算可以得到固体颗粒任何时候的温度。
7.
Temperature Integral and Thermal Analytic Kinetics Studies on the Thermal Decomposition Reactions;
温度积分及固体分解反应的热分析动力学研究
8.
The Gasification and Incineration Process Control of Industrial Solid Waste;
工业固体废弃物干馏气化焚烧的温度控制过程
9.
The Melt Temperature Treatment of Al-Si Alloy and Its Solidification Process;
Al-Si系合金的熔体温度处理及其凝固过程研究
10.
Research on Thermal Properties in Liquid-Solid Lubrication;
液—固二相流体润滑状态下的温度特性的研究
11.
The Heat Effect Problem of Blue Laser and It s Temperature Control;
蓝光固体激光器的热效应问题和温度控制
12.
Adaptability of Solid Lubricant at Extreme Temperature
固体自润滑材料极端温度环境适应能力研究
13.
Research on Influence Factor Originated from Granularity of Starting Materials in Synthesis of Zircon Powders by High Temperature Solid State Reaction
原料粒度对高温固相法制备锆英石粉体的影响
14.
Study on Sintered Temperature of Anode Substrates of Solid Oxide Fuel Cell
固体氧化物燃料电池阳极基底预烧温度的研究
15.
Analytical Solution of Temperature Field of Solid Rocket Motor Laminated Structure with High-Temperature Thermal Shock
高温热冲击下固体火箭发动机层合结构温度场解析解
16.
congelation point thermometer
测定凝固点用温度计
17.
The Effects of Casting Temperature and Humidity on the Structure and Performance of Fixed Carrier Composite Membrane for CO_2 Separation;
制膜湿度和温度对分离CO_2固定载体膜结构和性能的影响
18.
As the temperature falls, the atoms fall together, clump in lumps, and reduce to liquids, solids and molecules.
当温度下降时，原子挤在一起，集结成群，凝缩成液体，固体和分子。