1.
Study on Low-Frequency Torsional Vibration Tapping of Composite Al_2O_3p/Al
Al_2O_3p/Al复合材料低频扭转振动攻丝研究
2.
Study on Data Acquisition and Parameter Matching System of Low Frequency Vibration Tapping
低频振动攻丝控制与数据采集及参数匹配系统研究
3.
Research on Vibration Tapping Torque Model Based on Artificial Neural Network
基于BP神经网络的振动攻丝扭矩模型的研究
4.
Torsional vibration absorbers
GB/T16305-1996扭转振动减振器
5.
Calculation of Natural Frequency of Torsional Vibrations for an Enclosed Disc Shaft System
封闭盘轴系统扭转振动固有频率的计算
6.
The power magnitude of main peak frequency of dynamic tapping torque can be used for on_line detecting the tap wear.
提出了在频域内采用动态攻丝扭矩主要峰值频率的功率值实时检测丝锥磨损的方法。
7.
The results showed that the mount spacing can be varied to adjust the natural frequency of the rotational mode.
结果说明：改变隔振元件的间距能调整扭转振动的固有频率的大小。
8.
torsional vibration of engine crankshaft
内燃机轴系扭转振动
9.
Description of torsional vibration absorber characteristics
GB/T13437-1992扭转振动减振器特性描述
10.
When the adjusting ring is at the end of the stator, the first eigenfrequencies of longitudinal and torsional vibrations are of degeneration.
调整环处于定子端部时,可以实现定子纵向振动与扭转振动一阶固有频率的调谐。
11.
Lateral and torsional coupled vibration of a CSP mill
C SP轧机弯扭耦合振动频率研究
12.
The system using stepping motor as energy source roalises the torsional vibraticon of the tap and simplifies the mechanical structure.
本系统用步进电机作为动力源实现丝锥的扭转振动,简化了机械结构。
13.
Research on Testing Technique of Dynamic Torsion Moment and Twist Vibration on Revovling Component Bench
旋转构件实验台动扭矩及扭振测试技术研究
14.
Analysis and Control on Engine Cranktrain Torsional Vibration;
汽车发动机曲轴扭转振动分析及控制
15.
Analysis on the Torsional Vibration of Cardan Shaft on CRH5 Motor Car
CRH5型动车万向轴扭转振动分析
16.
Investigation of Small-Hole Vibration Tapping in Difficult-To-Cut Materials;
难加工材料小孔振动攻丝的试验研究
17.
Nonlinear Dynamics and Large?scale Torsional Vibration of Suspension Bridges
悬索桥的非线性动力行为及其大振幅扭转振动
18.
Study on the Torsional Vibrations of Foundations Resting on Saturated Grounds;
饱和地基上基础的扭转振动特性研究