1.
INERTIAL EFFECTS OF HYPOELASTIC CYLINDRICAL BAR OF GRADE ZERO UNDER SIMPLE EXTENSION OF CONSTANT VELOCITY
零级次弹性圆柱杆在常速度拉伸时的惯性效应
2.
Mathematical Model to Schedule Dieless Drawing Speed for Tapered Tubes
确定锥形管无模拉伸速度制度的数学模型
3.
At the same temperature, the as-cast lead brass has the finer prolongation at the higher velocity.
在温度相同条件下，在较高的拉伸速度下获得了大伸长率。
4.
Paper and board-Determination of tensile properties-Constant rate of elongation method
GB/T12914-1991纸和纸板抗张强度的测定法(恒速拉伸法)
5.
Research and Analysis of Abnormal Yield Strength During Tensile Test for Pipeline Steel
管线钢拉伸试验中异常屈服强度研究与分析
6.
The series presses special have Idle speed high, drawing adjustment etc and the draw. lamella piece of the ideal equipments.
本系列液压机具有空程速度高，拉伸力调整等特点，是拉伸薄板件的理想设备。
7.
Special Drawing Methods That Could Improved Drawing Deformation Degree
能提高拉伸变形程度的特殊拉伸方法
8.
paper and board-determination of tensile strength properties-part 2:constant rate of elongation method
纸和纸板抗张强度的测定法-第1部分：恒速拉伸法
9.
INERTIA EFFECTS OF HYPOELASTIC CYLINDRICAL BAR OF GRADE ZERO IN TENSION OF JUMPING VELOCITY
零级次弹性圆柱杆在阶跃速度拉伸时的惯性效应
10.
Strain rate effects on the integral burning velocity of laminar premixed CH4/air and C3H8/air flames
火焰拉伸对甲烷/空气和丙烷/空气层流燃烧速度的影响
11.
measuring method for stretched density of knitted fabrics
针织品拉伸密度测定法
12.
determination of the apparent initial circumferential tensile strength
表面内周拉伸强度的测
13.
Most stretch yarns can be extended from one and one-half to twice their normal or relaxed length.
大多数弹力丝可被拉伸到正常或松驰状态长度的1倍半到2倍。
14.
V-belts--Tensile strength and elongation test method
GB/T3686-1998V带拉伸强度和伸长率试验方法
15.
By forecasting the length of the elastic rope with linear regression anslysis, test vehicle's speed can be controlled acctrately.
用线性回归统计的方法预测橡皮绳拉伸长度，精确地控制了开环状态的试验车的碰撞速度。
16.
Flat transmission belting--Test method of full thickness tensile strength and elongation
GB/T6761-1986平带全厚度拉伸强度和伸长率测定方法
17.
The Effect of Tensile Test Rate on Test Result of X80 Grade Pipeline Steel
拉伸试验速率对X80级管线钢拉伸试验结果的影响
18.
As with the breaker drawing, rollers moving at different speeds smooth and combine the slivers and pull them into a thin layer then into the drawn sliver.
正如头道并条一样,不同速度的罗拉将条子并合、理顺并牵伸成薄层,然后并合成熟条。