1.
Cast Process of Winding in Epoxy Resin Cast Dry-Type Transformer
环氧树脂浇注干式变压器的绕组浇注工艺
2.
Study on effect of organic silicon resin on capability of epoxy resin cast
有机硅树脂对环氧树脂浇注体性能的影响
3.
The Environmental Aspects Analysis For Epoxy Cast Resin Dry-type Transformers
环氧树脂浇注干式变压器环保特性分析
4.
Development of JLSFW-10 Epoxyn Pouring Type Outdoor Three-phase Combined Transformer
JLSFW-10型环氧树脂浇注式户外三相组合互感器的研制
5.
Resin Vacuum Cast Process and Its Points for Attention
环氧树脂真空浇注工艺过程及注意事项
6.
Research on the vacuum casting epoxy insulating materials of high voltage cable accessory
高压电缆附件用真空浇注环氧树脂的研究
7.
Development of casting mould for epoxy resin insulating pull rod
环氧树脂应用于绝缘类零件的浇注模设计
8.
The Characteristics of Pouring Epoxy Resin Cushion and Its Application in Ships
浇注型环氧树脂垫片特性及在我国船舶中的应用
9.
The series of current transformers are resin insulated， fully enclosed and busbar type. The iron core is circular and the secondary winding goes around the core before casting by epoxy.
本型电流互感器的铁心为圆环形，二次绕组匀绕制在铁心圆周上，用环氧树脂混合料浇注成形。
10.
Relation of the Property of a Low Viscosity Epoxy Resin Casting Matrix to Its Degree of Cure
低粘度环氧树脂浇铸体性能与固化度的关系
11.
The current transformer is fully enclosed and busbar structure. The secondary windings and iron core are insulated by epoxy resin. It has a good ability of antipollution and moisture proof.
本型电流互感器为全封闭母线式结构，二次绕组及铁芯均浇注在环氧树脂内，耐污染及潮湿。
12.
The current transformer is fully enclosed. The primary and secondary windings and iron core are insulated by epoxy resin. It has a good ability of antipollution and moisture proof.
本型电流互感器为全封闭结构，一、次绕组及铁芯均浇注在环氧树脂内，耐污染及潮湿。
13.
Study on toughening of epoxy adhesives cured at room temperature for preparation of membrane module
膜组件浇铸用室温固化环氧树脂胶粘剂的增韧研究
14.
Study of heat-resistant epoxy adhesives cured at room temperature for the preparation of membrane modules
膜组件浇铸用室温固化环氧树脂耐热胶粘剂的研究
15.
Processing properties of epoxy resin system and phenolic resin for co-injection RTM process
用于共注射RTM工艺的环氧树脂和酚醛树脂的工艺特性
16.
Investigation of water-based epoxy resin modified mortar for perfusion-road surface
灌注式路面层用水性环氧树脂改性的砂浆性能
17.
epoxy seal transistor
环氧树脂封装晶体管
18.
epoxy polyester powder coating
环氧聚酯树脂粉末涂料