1.
Start-up Debug and Common Problem Treatment of Double-ring Type Sealing Oil System
双流环密封油系统启动调试及常见问题处理
2.
Comparison Between Single-ring Type and Double-ring Type Sealing Oil System of Generator
发电机单流环式和双流环式密封油系统比较
3.
Simple Analysis of the Single-ring Type Sealing Oil System in the QFR-400-2-20 Type Generator
QFR-400-2-20型发电机单流环式密封油系统
4.
Research on Omni-sealed Treatment System of UHV A.C.Transformer Oil
交流特高压变压器油全密封处理系统研究
5.
DSS tubing joint
双密封专用油管接头
6.
Faults analysis and its contermeasures to the sealing oil system of 300 MW generator
300MW机组密封油系统故障分析和对策
7.
Piston rings not sealing (oil being consumed by the engine).
活塞环没密封（引擎用油）。
8.
Development of Precise Vision Measuring System for Large Sized O-rings
大尺寸油浸密封圈精密图像检测系统的研制
9.
The Technological Reconstruction of the Shaft Sealing System for the Hydrogen Compressor of Continuously Reforming Unit;
重整循环氢压缩机密封系统技术改造
10.
Control system design of multi-parameters environment simulate hermetic cabin
多环境参数模拟密封舱控制系统设计
11.
The Analysis and Improvement on High-pressure Spherical Seal Failure of Aircraft Fuel System
飞机燃油系统高压球面密封的故障分析与改进
12.
Reconstruction and Design for Control System of Test-bed for a Rotary Sealing Ring;
回转式密封环试验台控制系统的改造与设计
13.
No sealing fan designing technique in the double-inlet and double-outlet tobe mill positive pressured direct-fired pulverizing system
无密封风机的双进双出磨煤机正压直吹式制粉系统设计
14.
Experimental Analysis on Multi-tube Pnumatic System for Ash Conveying;
双管紊流密相气力除灰系统试验研究
15.
Application and Dissemination of Double-Vortex Seal in Pipeline Pump.
双螺旋密封在长输油泵上的推广应用
16.
Numerical Study on Nonlinear Aerodynamic Excitation of Rotor-Bearing-Sealing Systems;
转子—轴承—密封系统非线性气流激振数值研究
17.
Numerical Investigation on Flow and Ingression of Disc Cavity in the Presence of Mainstream External Flow;
旋转盘腔系统流动及密封特性的数值研究
18.
The mixture of hydrogenated oils is pumped into the closed system and the fat solidifies on small refrigerated cylinders.
把混合的氢化油抽压进密封式系统，油脂便在小的冷冻滚筒上结晶。