1.
The CAPP of motor end cover components
电动机端盖零件的计算机辅助工艺设计
2.
Cold punching processing design of the FH_2-40 motor's rear cover
FH_2-40型电动机后端盖冷冲压工艺设计
3.
The Reliability Analysis on the End Covers of In-wheel-motor Under Locked Brake Condition
制动抱死工况下轮毂电机端盖的可靠性分析
4.
Analysis and Solution of Endshield-type Oil Leakage in High-Speed Motor
高速端盖式滑动电机轴承漏油问题的分析与解决措施
5.
hub cap for road motor vehicles or tractors
轴端盖,道路机动车辆或摩托车用
6.
Design of Automatic Figure Puncher at the End of Dynamic Theft-proofing Cap
气动防盗盖端面花纹自动冲压机的设计
7.
Cause of Excessive Temperature of Cover Bolt of Russia-made TBB-500-2EY3 Generator
俄制TBB-500-2EY3型发电机端盖螺栓温度高原因分析
8.
Turn the locking bolt so that it is fixed on the bake cover or the flange plate.
安装后必须将锁紧螺母锁紧在电机后端盖或法兰盘上。
9.
Turn the hollow bolt so that it is fixed on the bake cover or the flange plate.
安装后必须旋出空心螺栓锁紧在电机后端盖或法兰盘上。
10.
Brazing technology for end-ring and conducting bar of asynchronous traction motor
异步牵引电动机端环与导条钎焊技术
11.
"The cylinder of an internal-combustion engine is closed at one end by a plate called the head and open at the other end to permit free oscillation of the connecting rod, which joins the piston to the crankshaft."
内燃机的汽缸在一端用盖封住,叫做头,另一端敞开,使连接活塞和曲轴的连杆能自由摆动。
12.
Energy saving of a water injection system can be achieved by regulating the speed of the electromotor through changing the input voltage of the motor's stator.
电动机调端电压调速是通过改变电动机定子端电压来实现调速的方法。
13.
Research of General Electric Remote Terminal Controller in Aircraft Automatic Electrical Power System;
飞机自动配电系统通用电气远程终端技术研究
14.
The Design of Liquid-fixture to Turning Both Ends of The Motor Case Orifice
车削电动机机壳两端孔口的液性夹具设计
15.
Influence of Strain Electrical Measuring Method to Engine Jar Cover Temperature,Stress Measurement System
应变电测法对发动机缸盖测试系统的影响
16.
Research of a Lithium Battery Fully Automatic Bending Ears Capping Machine
锂电池全自动极耳折弯封盖机系统开发
17.
Remove the service valves and cap the compressor ports.
卸去维修阀门，并盖住压缩机端口。
18.
Study of Motivation Mechanism on Sales Staff in Mobile Telephone Enterprise;
移动电话企业终端销售人员激励机制研究