1.
The Reliability Analysis on the End Covers of In-wheel-motor Under Locked Brake Condition
制动抱死工况下轮毂电机端盖的可靠性分析
2.
Cause of Excessive Temperature of Cover Bolt of Russia-made TBB-500-2EY3 Generator
俄制TBB-500-2EY3型发电机端盖螺栓温度高原因分析
3.
Cold punching processing design of the FH_2-40 motor's rear cover
FH_2-40型电动机后端盖冷冲压工艺设计
4.
The CAPP of motor end cover components
电动机端盖零件的计算机辅助工艺设计
5.
Turn the locking bolt so that it is fixed on the bake cover or the flange plate.
安装后必须将锁紧螺母锁紧在电机后端盖或法兰盘上。
6.
Turn the hollow bolt so that it is fixed on the bake cover or the flange plate.
安装后必须旋出空心螺栓锁紧在电机后端盖或法兰盘上。
7.
Analysis and Solution of Endshield-type Oil Leakage in High-Speed Motor
高速端盖式滑动电机轴承漏油问题的分析与解决措施
8.
hub cap for road motor vehicles or tractors
轴端盖,道路机动车辆或摩托车用
9.
Remove the service valves and cap the compressor ports.
卸去维修阀门，并盖住压缩机端口。
10.
a detachable plate that covers the closed end of a cylinder chamber in a reciprocating engine or pump.
覆盖在往复式发电机引擎的汽缸内腔的封闭一端的可分离的盘状物体。
11.
power line carrier telephone terminal
电力线载波电话终端机
12.
THE APPLICATION AND DESIGN OF THE CAM INDEX DRIVE IN A CAP SCREWER
旋盖机端面蜗形凸轮机构的应用与设计
13.
Two brass and caps: Made of brass of good conductivity.
2两端铜盖:须以导电率良好之黄铜为材料.
14.
teleprinter terminal unit
电传打字机终端装置
15.
voice-frequency carrier telegraph terminal
音频载波电报终端机
16.
digital carrier telephone terminal machine
数字载波电话终端机
17.
single-channel carrier frequency telephone terminal
单路载频电话终端机
18.
multichannel carrier-frequency telephone terminal
多路载频电话终端机