1.
Analysing of Profile Plate and Cam Mechanism Designing for Drawtwister
牵伸加捻机成形模板与锭子变速凸轮设计分析
2.
continuous spin-draw twister
连续纺丝拉伸加捻机
3.
friction-twist draw-texturing machine
摩擦加捻拉伸变形机
4.
"Spinning is the process of drawing out and twisting a mass of cleaned, prepared fibres. Filament yarns generally require less twist than do staple yarns."
纺纱是对纤维集合体牵伸加捻的过程。长丝比短纤维需要的捻度少。
5.
Process Analysis about the Additional Pressure Bar in the Drafting Zone on the Spinning Frame
细纱机牵伸区附加压力棒牵伸工艺分析
6.
cross-wound draw-twisting package
交叉卷绕拉伸加捻筒子
7.
The mathematical analysis of multi-zone roller stretching for untwisted fiber sheet
无捻纤维片多区罗拉牵伸的数学分析(英文)
8.
Quality Contrast of Resultant Yarn with Spinning Frames Equipped with Draft Press Bar in the Rear Area
细纱机后区加装压力棒牵伸的成纱质量对比
9.
DISCUSSION ON THE DRAWING MECHANISM IN THE SDS DRAWTEXTURING MACHINE
探讨SDS型假捻变形机中的拉伸机构
10.
pin drafter
针梳牵伸机, 针梳机
11.
Drawing machine under pressurized steam is key equipment for preparation high quatity PAN precursors.
加压水蒸汽牵伸机是制取高性能碳纤维原丝的关键设备。
12.
Production and Study of Bright N-6 16.7 dtex/5f Drawn Yarn
普通加弹机开发生产有光牵伸丝的工艺设备探讨
13.
During the drawing an adhesive is applied by rollers.
在牵伸过程中,通过罗拉施加粘合剂。
14.
It pointed out that the drafting of mule should better use combination drafting and select right proportion of different drafting with different material.
文章指出，走锭细纱机牵伸应尽量采用混合牵伸方法，根据原料变化相应调整牵伸分配。
15.
After combing, the comb sliver is drafted or drawn to form a roving, which is delivered to a spinning frame where the final worsted yarn is made.
经精梳机后,精梳毛条再去被牵伸成粗纱,粗纱再由细纱机加工。最终的纱线在细纱机上生成。
16.
Effect of pressure bar in back drafting zone of SKF drafting system on spun yarn quality and optimizing drafting ratio
细纱机后区压力棒牵伸的效果及牵伸倍数的优化
17.
Determination of twist in yarns-Untwist-retwist method
GB/T2543.2-1989纱线捻度的测定退捻加捻法
18.
During spinning the roving is attenuated to the desired diameter, and the desired amount of twist is inserted.
在细纱生产中,粗纱被拉伸至所需要的细度,同时加上适当的捻度。