1.
The roundness tolerance equals to the difference between max. and min. outer diam. obtained by measuring at3 or more equable parts.
②圆度公差等于三等分或多等分测量所取得的最大或最小外径之差。
2.
The roundness tolerance equals to the difference between max.and min. outer diam.obtained by measuring at 3 or more equable parts.
圆度公差等于三等分或多等分测量所取得的最大或最小外径之差。
3.
Tolerance of Wire Diameters & Ovality
圆径及偏圆度之公差
4.
Diameter Tolerance, Ovality and Average Decarburized Layer Depth
直径公差，偏圆度及脱碳层的平均深度
5.
The research on the measuring round error and the statistical distributing of round error
圆度误差评定方法及圆度误差统计分布的研究
6.
Study of the System of Cylinder Wall's Roundness Error Measurement Online
圆筒内壁圆度误差在线检测系统研究
7.
Analysis of the Cylindricity Tolerance and Press Mounting Curves of Axle Wheel Seat and Wheel Hub Bore
关于车轴轮座、车轮轮毂孔的圆柱度公差和压装曲线分析
8.
Cylinder Wall's Roundness Testing System Online and the Accuracy on Research
圆筒内壁圆度误差在线检测系统及精度研究
9.
Tolerances and specification of taper gauges
GB/T11852-1989圆锥量规公差与技术条件
10.
Accuracy Analysis of Signal to Measure a Circle by Using 3 Point EST Method
三点法误差分离测圆信号的精度分析
11.
Measurement & Error Analysis of Cylindrical Indexing Cam
圆柱分度凸轮廓面的测量及误差分析
12.
Research on Measurement of Roundness Error Based on the Laser Interferometer
基于激光干涉仪的圆度误差检测研究
13.
Analyzing Efficiency of Datum Deleting of α-hull in Evaluation of Roundness Error
圆度误差评定中α-壳的删点效率分析
14.
Evaluation Algorithm of Cylindricity Error Based on Coordinate Transformation
基于坐标变换的圆柱度误差评定算法
15.
Geometrical tolerance-Positional tolerancing
GB/T13319-1991形状和位置公差位置度公差
16.
The Effects of Angle Windage on the Linking Intensity of Interference Fits;
圆锥母线角度偏差对过盈联接强度的影响
17.
Research on Roundness On-machine Measurement Based on Multiscale Analysis
基于多尺度分析的圆度误差在线检测研究
18.
Data Processing System of Cylindricity Error based 0n Optics Diagraph
光学分度头测量圆柱度误差的数据处理系统