1.
Simulation Study on Fluidized Bed Carburizing Layer Depth Mathematic Model
流态化渗碳层深度数学模型仿真研究
2.
Online detecting for carburizing depth of iron and steel parts based on Online LS-SVM
基于Online LS-SVM的钢铁件渗碳层深度在线检测
3.
Wavelet Analysis Application on Eddy Current Testing Signal Processing of Carburized Layer Depth;
小波分析在渗碳层深度涡流检测信号处理中的应用
4.
Measurement on the carbonizing or nitro-caburizing harden case depth of sintering iron-based material
GB/T9095-1988烧结铁基材料渗碳或碳氮共渗硬化层深度的测定
5.
Model for the distribution of carburized case depth of spur gear in warm forming after car burizing
直齿轮“渗碳-温挤”渗碳层厚度分布模型
6.
Surface Compound Treatment of C-N Multi-elements and RE-B-C-N Multi-elements Deep-penetrating
碳氮共渗-深层稀土硼碳氮共渗复合处理
7.
Sim? ilarly, an increase in case depth, particularly uneven case depth in case hardening steels, increases warpage on quenching.
与此类似，渗碳层厚度越大，特别是对于渗碳层厚度不一的渗碳用钢，淬火时更易产生翘曲。
8.
Influence of nitrocarburizing on microstructure and roughness of 4Cr10Si2Mo steel
氮碳共渗对4Cr10Si2Mo钢渗层组织和表面粗糙度的影响
9.
Diameter Tolerance, Ovality and Average Decarburized Layer Depth
直径公差，偏圆度及脱碳层的平均深度
10.
EVOIL? ALMOND applies easily, offers deep penetration and significant moisture retention together with high nourishing properties.
使用方便，深层渗透，超强保湿，高度滋养。
11.
Permissible depth of flaw and decarburized layer
裂纹之容许深度及脱碳层
12.
Determination of depth of decarborization of steel
GB/T224-1987钢的脱碳层深度测定法
13.
Surface combined treatment of carbonitriding and B-C-N-RE multi-elements deep-penetrating on 20Cr steel firebrick die
碳氮共渗-深层稀土硼碳氮共渗复合处理在20Cr钢耐火砖模具中的应用
14.
Microstructure and Hardness of Cr,B,C Ternary Cast-infiltrated on 45 Steel Surface
45钢表面铬、硼、碳三元铸渗层的组织和硬度
15.
Technologies for improving producing degree of low permeability carbonate reservoirs
提高低渗碳酸盐岩储集层动用程度技术
16.
Influence of plasma carburizing temperature on microstructure and properties of carburized layer for AISI 316L stainless steel
离子渗碳温度对316L不锈钢渗层组织和性能的影响
17.
The finished part shall have a nitride case depth that does not exihibit porosity that extends deeper than the outer half of the nitride case depth.
成品件外表面渗氮，只允许在渗氮层的靠外表面的渗层一半深度存在缩孔。
18.
The intensive stimulation technologies of carbonate reservoirs in deep and ultra-deep wells:A case study of the Tarim Oilfield
深井超深井碳酸盐岩储层深度改造技术——以塔里木油田为例