1.
New cylinder head bolts should be use
应使用新的汽缸头螺栓。
2.
Remove the engine cylinder head bolts.
拆卸引擎汽缸头螺栓。
3.
Remove manifold from the cylinder hea
从汽缸头拆下歧管。
4.
Place the engine cylinder head over the dowels.
将引擎汽缸头放在销上。
5.
Remove cylinder head cover, refer to cylinder head cover removal in this section.
拆下汽缸头盖，请参阅本节中的汽缸头盖的拆卸。
6.
Engine Cylinder Head Bolt Tightening Sequence
引擎汽缸头螺栓锁紧顺序
7.
Remove bolts, nuts and washers attaching manifold to cylinder hea
拆下系附在汽缸头的螺栓，螺帽和垫圈。
8.
Clean the exhaust manifold and cylinder head mating surfaces.
清洁排气歧管和汽缸头配合面。
9.
The cylinder head is heavily finned for strength.
汽缸头附有许多突片以增加强度。
10.
Remove control cables from cylinder head cover clip.
从汽缸头盖扣夹上移去控制拉索。
11.
Repeat the measurement with contacts lengthwise to engine cylinder hea
纵向接触到引擎汽缸头，重复测量。
12.
Tighten exhaust manifold to cylinder head bolts.
紧固排气岐管汽缸头螺栓。
13.
Aluminum-copper alloy which when heat-treated has good strength at high temperature is used for making pistons and cylinder heads for automobiles.
由于铜铝合金经过热处理之后具有良好的高温强度，所以用来制造汽车发动机的活塞与汽缸头。
14.
SR cylinder oil
直接蒸汽拔头汽缸油
15.
Whose butts are those in the car ash tray?
汽车烟灰缸里的那些烟头是谁抽的?
16.
An eight-cylinder engine or motor vehicle.
八汽缸发动机或八汽缸汽车
17.
Position the cylinder heads onto head gaskets and cylinder block.
将汽缸盖安置到汽缸盖罩垫和汽缸体上。
18.
EEB 5L Six Cylinder SOHC Gasoline
EEB5L六缸SOHC汽油