1.
Coupling Analysis of Dynamics Tribology and Elastic Mechanics for a Crankshaft Bearing System
计入曲轴倾斜时曲轴-轴承系统动力学摩擦学和弹性力学耦合分析
2.
Coupling Researches on Tribological and Dynamical Behaviors of the Crankshaft-Bearing System of Internal Combustion Engines;
内燃机曲轴-轴承系统摩擦学动力学耦合研究
3.
Coupling Research on Tribology, Stiffness and Strength of Crankshaft-bearing System;
曲轴—轴承系统摩擦学、刚度和强度的耦合研究
4.
upper center crankshaft bearing
曲轴主轴承上中轴瓦
5.
Analytical Investigation on Strength and Main Bearing Lubrication of CA4D32 Diesel Engine Crankshaft System Based on a Simulation Technique;
柴油机曲轴轴系强度和主轴承润滑仿真研究
6.
Modeling for Rotor System of AC Magnetic Bearing Electric Spindle;
交流磁轴承支承电主轴转子系统建模
7.
Coupling Researches on Dynamics Tribology Stiffness and Strength in the Crankshaft-Bearing System of Internal Combustion Engine;
内燃机曲轴—轴承系统动力学摩擦学刚度和强度耦合研究
8.
The feed holes for the crankshaft main bearings.
曲轴主轴承进入口。
9.
Crankshaft and main bearings service
曲轴和主轴承的维修
10.
Positive crankcase ventilation (PCV)
积极式曲轴箱通风系统
11.
crankcase emission control system
曲轴箱排放物控制系统
12.
The Monitoring System of Orbit of Shaft Center of Active Magnetic Bearing Based on LabVIEW
基于LabVIEW的磁力轴承轴心轨迹监测系统
13.
The crankcase ventilation system carries fresh air through the crankcase.
曲轴箱通风系统要携带新鲜的空气通过曲轴箱。
14.
Emulation and Caculation of Hydroelectric Generation Set Shafting Base on Rotor Bearing System;
基于转子轴承系统的水轮机主轴系统仿真计算
15.
Dynamic Behavior of a shaft-rolling bearing system with clearance
计入轴承间隙时轴-滚动轴承系统动力学行为研究
16.
Precise determination of windings axes angle and model stiffness coefficients for bearingless motors
无轴承电机绕组轴线及控制系统刚度系数测定
17.
Development of the Recognition System for output Shaft Type of Gasoline Engine Crank;
汽油发动机曲轴输出轴类型识别系统的研制
18.
Pilot bearing in crankshaft. The pilot bearing in the crankshaft is usually either a Bushing or a Ball bearing.
曲轴上的导向轴承:曲轴上的导向轴承一般或者是轴瓦,或者是球轴承。