1.
The Mohr-Coulomb model is based on plotting Mohr's circle for states of stress at failure in the plane of the maximum and minimum principal stresses.
莫尔－库仑模式基于莫尔圆来判断最大和最小主应力平面上的破坏应力状态。
2.
Supplementary Regulations on Deciding the Place of Main Plain in the State of Plain Stree;
确定平面应力状态主平面位置的一个补充规定
3.
Shortcut of Determining the Direction of the Largest Main Stress under the Status of Plane Stress;
平面应力状态下判定最大主应力方向的捷径
4.
Intuitive Judgment of Maximum Principal Stress′s Direction of Plane Stree Statements;
平面应力状态最大主应力方向的直观判定
5.
Further Discussion for Explorations Confirming Method of Principl Stress Direction under the Plane Stress Condition;
平面应力状态主应力方向确定方法再探
6.
In every state of stress there exist at least three principal planes, which are mutually perpendicular.
对每一种应力状态，至少存在三个主平面，它们互相垂直。
7.
A Simple Rule of Visual Determining Main Direction s General Position Under Horizontal Stress State;
直观确定平面应力状态下主方向大体位置的简单规则
8.
The two cases of plane stress and plane strain will be discussed separately.
平面应力和平面应变这两种情况将分开讨论。
9.
There are two plane problems in the theory of elasticity, the problems of plane strain and of plane stress.
弹性理论中有两类平面问题，即平面应变和平面应力问题。
10.
The analysis covers plane strain, plane stress and anti-plane strain shear cases.
分析包括了平面应变、面应力和出平面应变剪切三种情况。
11.
Shear stress arises from forces that are parallel to the plane of the cross section.
切应力由平行于截面的力引起。
12.
Dynamics Analysis of Main Bodies of Super Precise Surface Grinding Machine
超精密平面磨床主体结构动力学分析
13.
Relation of Out-of-Plane and In-Plane Stresses for Elastic-Plastic Plane Strain Problems
平面应变弹塑性问题中面外应力与面内应力的关系
14.
On Perfectly Stress Field at a Mixed-Mode Crack Tip under Plane and Anti-Plane Strain
关于平面应变和反平面应变复合型裂纹尖端的理想塑性应力场
15.
Under these conditions the state of stress is predominantly plane stress.
在这些条件下，应力状态是平面应力占优势。
16.
The Study of Using Acoustoelastic Method for the Stress Analysis in a Plane Stress Field
用声弹性法对平面应力场进行应力分析的研究
17.
We defined the conditions of the plane stress distribution of thin plates subjected to in-plane forces.
我们定义了承受平面力的薄板平面应力分布条件。
18.
STEP HOLE DRILLING METHOD FOR MEASURING PLANE RESIDUAL STRESSES IN DEEP LAYER
钻阶梯形孔法测量深层平面残余应力