1.
Force and Strength Analysis on End Face Engagement Cycloid Steel Ball Planeary Transmission
端面啮合摆线钢球行星传动啮合副力及强度分析
2.
STUDY ON THE DYNAMICAL PERFORMANCE OF END FACE ENGAGEMENT CYCLOID STEEL BALL PLANETARY TRANSMISSION;
端面啮合摆线钢球行星传动的动力性能研究
3.
On Meshing Area of Meshing Pair of Oscillating-teeth End-face Harmonic Gear;
活齿端面谐波齿轮啮合副的啮合面积研究
4.
The Researches on Modification of Tooth Surface of End Face Harmonic Gear Drive of Oscillating Teeth;
活齿端面谐波齿轮啮合副齿面修形的研究
5.
The Meshing Researches on Asymmetrical Tooth Shape of Oscillating-teeth End-face Harmonic Gear;
活齿端面谐波齿轮非对称齿形的啮合研究
6.
Engagement Analysis of Conical Twin-screw and Dynamic Simulating of the End Section
锥双螺杆的啮合分析及其端面过程动态模拟
7.
The Researches on the Specific Pressure and the Contact Stress of the End Face Harmonic Gear Drive of Oscillating Teeth;
活齿端面谐波齿轮啮合副的比压及接触强度的研究
8.
gear single flank rolling tester
齿轮单面啮合检查仪
9.
gear two flank rolling tester
齿轮双面啮合检查仪
10.
one-flank gear rolling tester
单面啮合齿轮检查仪
11.
dual flank gear rolling tester
双面齿轮啮合检查仪
12.
gear wheels that mesh in the same plane.
啮合在同一平面的齿轮。
13.
Meshing Theory and Application of Dual Meshing Silent Chain Drive;
双面啮合齿形链传动的啮合理论与应用研究
14.
Research on meshing characteristics-based design of point-contact tooth surface
基于预定啮合特性的点啮合齿面设计方法
15.
Study on the Formation of Spur Face Gear Tooth Profile and Meshing Simulation;
直齿面齿轮齿面生成方法与啮合仿真
16.
whole tolerance single-side mating gear detector winch
全误差式齿轮单面啮合检查仪绞车
17.
The Experiment Research of Hard Gear-face Point-line Meshing gear Transmission;
硬齿面点线啮合齿轮传动的试验研究
18.
Study on Meshing Analysis and Meshing Control of Double-enveloping Hourglass Worm-gearing Affected by Misalignment Errors and Load-dependent Deformation
制造误差与承载变形耦合条件下平面二次包络环面蜗杆的啮合分析与啮合控制研究