1.
The Application on the Progressive Control Method of Land Plot for Renewal and Conservation in Regulatory Detailed Planning;
渐进式保留与更新地块控制方法在控制性详细规划中的应用
2.
FAR(Floor Area Ratio) Leads to Take Value IntervalQuantify under the Control of Method Studying in Old City Renewal
旧城更新中地块容积率取值区间定量控制方法研究
3.
Control of fault blocks upon the Late Permian reservoirs of reef facies in the Upper Yangtze Platform and exploration suggestions
上扬子台地晚二叠世礁相油气藏的断块构造控制与勘探方法建议
4.
Realization of key modules in quality control system for regional geochemical sample analysis
区域地球化学样品分析质量控制系统关键模块的实现方法
5.
Macro-block layer rate control method in low bit-rate for H.264
低码率下的H.264宏块级码率控制方法
6.
Design of Long-range Control Module based on GSM and ARM 9
基于GSM和ARM9远程控制模块的设计方法
7.
Study on Decentralized Control for Reconfigurable and Modular Robots;
可重构模块化机器人的分散控制方法研究
8.
STUDY ON THE METHOD OF OIL/GAS-BEARING BLOCK COST DIFFERENCE ANALYSIS AND CONTROL;
油气断块成本差异分析与控制方法研究
9.
Method to Design Modular Based Car Body Control Systems
车身网络控制系统的模块化设计方法研究
10.
Design and Research on Modularization and Per-Unit of Vector Control System
矢量控制系统的模块化标幺化设计方法研究
11.
Control-flow Checking Performance Optimization Method Based on Basic Block Reduce
采用基本块规约的控制流检测性能优化方法
12.
Modular Design Method of Car Body Network Control Systems
车身网络控制系统开发的模块化设计方法
13.
The storage control block address is invalid.
存储控制块地址无效。
14.
The Study on Design Methods of Master Card of Automotive Electronic Control System Development Equipment Based on PCI Bus;
基于PCI总线汽车电子控制开发装置控制器模块开发设计方法研究
15.
The Modularization Modeling of Vehicle and the Simulation Research on the Control Method of Anti-lock Braking System during the Steering Braking;
转向制动工况下的车辆模块化建模及防抱控制方法的仿真研究
16.
After that,a design method that is called block dia gonal controller(BDC) is proposed.
然后提出了一种由逆解所组成的块对角控制器的设计方法。
17.
Modeling and Differential Geometry Flux Decoupled Control of Planar Integrating Magnetic VRM;
平面磁集成电压调整模块建模方法及磁耦合微分几何解耦控制
18.
A Study on Dynamic Control and Fault Diagnosis for Reconfigurable and Modular Robots;
可重构模块机器人动力学控制与故障诊断方法研究