1.
impeller clearance
叶轮间隙;叶片间隙;导向叶片与工作叶片的间隙
2.
impeller-diffuser clearance
(浮选机) 叶轮扩散器间隙
3.
3D-PIV Measurements in Clearance between the Impeller and the Diffuser of an Axial Flow Pump;
轴流泵叶轮与导叶轴向间隙内流场的3D-PIV测量
4.
Research on Numerical Calculation and Analysis of HPT Tip Clearance;
高压涡轮叶尖间隙数值计算与分析研究
5.
Numerical Research of Tip Clearance Flow Structure in a Pivoting-Stator of Radial Inflow Turbines
向心涡轮可调导叶间隙流动的数值研究
6.
Effects of endwall relative motion on tip clearance flow in turbine rotors
机匣相对转动对涡轮叶顶间隙流动的影响
7.
A Numerical Simulation Consideration an Exhaust Gas Turbine Stage Cascade with Tip Clearance
计及动叶顶部间隙影响的烟气涡轮数值模拟
8.
Effect of different incidences on turbine cascades flow in blade tip clearance
冲角变化对涡轮叶栅内间隙流动的影响
9.
Effects of Turbine Tip Clearance on Gas Turbine Performance
叶尖间隙对涡轮气动性能影响的试验研究
10.
SIMULATION OF EFFECTS OF BLADE ROTATION ON TIP CLEARACNE FLOW IN AXIAL TURBINES
叶片转动对涡轮间隙内部流动影响的数值研究
11.
Design of High Efficiency Turbine with Large Tip Clearance for Rocket Engine
大叶顶间隙高效率火箭发动机涡轮设计
12.
Be sure of at least 25 mm (0 inches) between tips of fan blades and fan shrou
确认风扇叶轮与风扇罩之间至少有25公厘（0英寸）的间隙。
13.
The compensating rings of axle bush are redesigned and interval between impellers and clapboards are adjusted.
重新设计轴瓦补偿圈 ,调整叶轮与隔板之间的间隙 ;
14.
Gear-to-Body Clearance (Radial)
齿轮至缸体间隙(径向)
15.
Therefore,for the adjustable blade spiral mixed flow pump,the design of fixed guide blade should be paid attention to and the tip clearance of blade should be rationally selected.
因此，对于可调叶片蜗壳式混流泵应重视固定导叶的设计，合理地选择轮缘间隙的大小。
16.
Clogging up of the cooling air slits in the turbine blades is primarily caused by ultrafine particles with a high specific surface area.
涡轮叶片之间冷却空气缝隙的堵塞主要是因为存在高比表面积的超细粒子。
17.
In the lobed impeller the measuring chambers are the space between the lobes and the meter housing.
叶轮式测量室是叶轮和流量叶壳体间的空间。
18.
Research on Measurement of Dynamic Gap of Gas Turbine Based on FPGA
基于FPGA燃气轮机动态间隙测量的研究