1.
Analysis of Influence Factors on Marine Diesel Engine Crankshaft Deflection and Study of Digital Measuring Instrument;
船舶柴油机曲轴臂距差影响因素分析及数字显示测量仪研究
2.
Research on Non-contact Measurement Technology of Two Axes' Parallel Error for Crankshaft;
曲臂两臂轴线平行度误差非接触检测技术研究
3.
engine supporting arm
发动机曲轴箱支座臂
4.
Relationship of the area under ROC curve with ntercept and slope
ROC曲线下面积与其在标准偏差轴上的截距、斜率关系
5.
hyperbolic positioning
双曲线定位，测距差定位
6.
The axial force is large in the cantilever, and it has some kind of偏心距?!
工程系：悬臂梁的轴压不小啊，还有点偏心距。。。。
7.
Analysis of Inspection and Measuring Method for 120° Distributing Angle Errors of Crankshaft Crankpins
曲轴曲拐120°角度误差检测方法分析
8.
The Influence Analysis on Precision of Press Caused by the Diameter Deviation of the Crank Supporting Neck
曲轴支承颈的轴径误差对压力机精度影响分析
9.
Effect caused by range curvature distinction for deception jamming under SAR imaging
距离弯曲差对SAR欺骗干扰成像的影响
10.
Dynamic Error and Compensation in Noncircular Crankshaft Grinding
曲轴非圆磨削运动中动态误差及补偿
11.
The Distortion of the Labor Market,the Difference in its Efficiency,and the Income Disparity between Peasants and Town People
劳动力市场扭曲、效率差异与城乡收入差距
12.
(geometry) a ratio describing the shape of a conic section; the ratio of the distance between the foci to the length of the major axis.
描述圆锥曲线部分形状的比率；长轴长度与焦距距离比。
13.
The distance from the origin to the point at which a line, curve, or surface intersects a coordinate axis.
截距从原点到一条直线、曲线或平面上的点的距离，与坐标轴相交
14.
Mount the arms on the pivot shafts so that the distance from the lower edge of the wiper arm tip to the upper edge of the lower windshield moulding is:
将雨刷臂安装在枢轴上以便使从雨刷臂边缘尖端到挡风模组上端边缘的距离是：
15.
Research on Automobile DAD Rapid-detection System Based on Machine Vision;
基于机器视觉的汽车轴距差快速检测系统研究
16.
Research on the Piezoelectric Detection Method of the Vehicle Wheelbase Based on Tires Western
轮胎印迹压电式汽车轴距差检测方法的研究
17.
Fast measuring of axle distance difference based on monocular vision for ground mark recognition of vehicular wheel
单目视觉车轮接地印迹识别的轴距差快速测量
18.
To study relationship area under ROC curve with intercept and slope.
目的 探索ROC曲线下面积与ROC曲线在ND轴上的截距、斜率的关系。